COATS Kit 8185531 User Manual

8185589 00 10/05 1 of 2 © COPYRIGHT 2005 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.

44--iinncchh CCllaammpp EExxtteennssiioonn oorr

22--iinncchh CCllaammpp RReedduuccttiioonn

KKiitt ##88118855553311

FFoorr UUssee WWiitthh CCooaattss

MMooddeell 99002244 TTiirree CChhaannggeerr

COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565

[phone] • [phone] • [phone] FAX • www.Hennessy-Ind.com

Make sure that the support is well
positioned, as shown. Introduce pin
A into hole B.

Secure the pin by the rubber fas­tening cable. Repeat the same pro­cedure for the other clamps.

Set the extension on the clamp,

as shown.

Extension Instructions

Reduction Instructions

Use an 8mm hexagonal wrench to

loosen the clamp screw.

Turn the clamp by 180 degrees. Use the 8mm hexagonal wrench

to tighten the screw.

Turn the whole clamp support on

the turntable by 180 degrees.

Set the support on the clamp.

Set the pin and lock it by the rub-

ber fastening cable.

Repeat the same procedure for

the other clamps.

8185589 00 10/05 2 of 2 © COPYRIGHT 2005 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.