COATS Kit 8184381 User Manual

Machine Preparation

1. Disconnect the tire changer from its air supply
and bleed off all air pressure. Also, disconnect
machine from power source.

2. Remove side panel from chassis for access of
internal parts.

3. Loosen coupling nut completely on 90-degree fit­ting at bottom of original air tank.

4. Loosen two 6mm screws securing air tank to
back panel of machine.

5. Remove air tank by lifting it off of the two 6mm
screws previously loosened.

6. Remove the 90-degree coupling from the 1-inch
pipe attached to the air valve located inside the
machine being careful not to damage the plastic air
lines attached to it.

Installation of the Replacement Tank

1. Remove the tank assembly from its shipping box
carefully so that the air gauge and manifold assembly
are not damaged.

2. Loosen the coupling nut completely and remove
the coupling half from the tank assembly. Apply
thread sealer to the outside of the 1-inch male pipe
threads, thread on the coupling half and tighten
securely.

3. Hang the new tank assembly on the two 6mm
screws previously loosened for removal of the old
tank. Note: Key hole slots are provided on the tank
bracket for this purpose.

4. Reattach the air valve assembly to the tank
assembly using the 1-inch coupling being careful to
position the air valve inside the machine to its original
position. Note: Do not damage the attached airlines in
this process.

5. Tighten the two 6mm screws securing the tank
in its final position.

6. Reattach the air supply to the machine, check for
air leaks and replace the side panel.

7. Cycle all functions on the machine.

8184383 00 07/02

© COPYRIGHT 2002 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.

99002244,, 99001100 AASSMMEE SSuurrggee TTaannkk FFiittmmeenntt

88118844338811 TTaannkk KKiitt

COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565

[phone] • [phone] • [phone] FAX • www.ammcoats.com

Figure 2 - Machine with New Tank Pointing Out Critical
Parts

Figure 1 - Picture of Machine Pointing Out Critical Parts Tank
Removal

90-degree

Coupling

Air Valve Location

90-degree

Coupling

Air Valve
Location

Parts Identification on the back.

Item Qty. Part No. Description

1 1 8181569 Gauge Tee Assembly
2 4 8102459 Self Tapping Bolt
3 1 8184382 Tank Mtg. Bracket
4 1 8113109 90 ELL Fitting
5 1 8181140 Nipple Fitting
6 1 8113108 1-inch NPT Nipple Fitting
7 1 8113099 1-inch NPT Union Fitting
8 1 107927 Surge Tank

Parts Identification

1

3

8

NOTE:

APPLY THREAD SEALER TO ALL
JOINTS DURING ASSEMBLY

2

5

7

4

6