COATS Kit 8183061 User Manual

8183063 04 06/09 © COPYRIGHT 1995 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.

Duckhead™ Mount/Demount Tool

Upgrade Kit 8183061

COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565

[phone] • [phone] • [phone] FAX

Note:

These instructions are to be used

on tapered vertical slide shafts only.

Nylon mount/demount tools are not cov­ered under regular warranty as these items
are expendable.

Mount/Demont Tool Head Adjustment

To Adjust Tool Head Lift

Shoulder screw (ref.1) sets the tool head lift for
metal duckheads – no adjustment required. Place
shim 85606345 on screw if using a plastic duck­head.

To Adjust Lock Tightness

With lock handle unlocked, loosen jam nut (ref. 2)
and adjust pin (ref. 3) until a slight firmness is
obtained, then tighten jam nut and check. Also
recheck tool head lift at this time.