A FOUNDATION IS REQUIRED WITH 3 SLAT CONFIGURATION
COASTER TETON TWIN/FULL BUNK
4859/4860
7030-00397
PARTS LIST:
A) 32-4 1/4" Lag Bolts
B) 32-Black Steel Washers
C) 2 -End Assemblies
D) 2 -3 ¼” x 75" Mattress Rails w/Support Cleats
E) 2 -5” x 75" Mattress Rails w/Support Cleats
F) 4 -3 ¼” x 75" Guard Rails
G) 3 -3 1/2" x 38 1/2" Mattress Supports
H) 3 -3 1/2" x 53 1/2" Mattress Supports
I) 12-1 1/4" Wood Screws
TOOLS REQUIRED:
1) 7/16" Wrench or Socket Wrench
2) Phillips Head Screwdriver
NOTE: Tool recommended: Electric driver with 7/16” socket
ASSEMBLY INSTRUCTIONS:
NOTE:
Make sure you have all
purchased your bed.
1) Attach two 3 ¼” x 75" mattress rails(D) to the lower portion of two end assemblies(C) with 8 lag bolts and 8 washers, and
tighten.
2) Attach two 5” x 75" mattress rails(E) and four guard rails(F) to the top portion of the end assembly with 16 lag bolts and 16
washers, and tighten.
3) Place 3 short mattress supports on mattress rail support cleats on top bed assembly, with one support in the center, and
a support pushed tightly against each end assembly. Repeat with 3 long mattress supports on bottom bed assembly.
4) Secure mattress supports with 12 wood screws.
5) Add bunk boards for proper support and thickness of the innerspring bunk mattresses. See dealer for details.
parts before beginning assembly. If you need a part, contact the dealer where you
Installation of individual slats for use with
Bunkie Board
(Bunkie Board sold separately)
See your retailer for purchase of Bunkie
Board
INDIVIDUAL
SLATS
INDIVIDUAL
SLATS
INDIVIDUAL
SLATS
SCREWSSCREWSSCREWSSCREWSSCREWSSCREWS
SCREW
Installation of individual slats for use with
Slat Roll
(Slat roll sold separately)
See your retailer for purchase of Slat Roll
SCREW
Individual Slat
SCREW
Individual Slat
INDIVIDUAL
SLATS
INDIVIDUAL
SLATS
INDIVIDUAL
SLATS
Individual Slat
SCREW
SCREW
individual slats should be placed evenly in the gaps
and underneath the strapping before fastening.
When used with a slat roll, the three
SCREW
SCREW
SCREW
SCREW
SCREW
Loading...