ASSEMBLY INSTRUCTIONS
PAGE 1 OF 4
BOOKCASE
802613
REVISION 0: 11/16/2018
COASTER FINE FURNITURE
www.coastercompany.com
ASSEMBLY TIME :
45 MINUTES
PARTS IDENTIFICATION
A.SHELF
B.SIDE FRAME
BOLT (1/4" x 12mm SR)
SCREW (28mm SR)
4PCS
2PCS
C.BACK
SUPPORT 1
D.BACK
SUPPORT 2
HARDWARE IDENTIFICATION
1PC
1PC
5PCS
16PCS
NUT(1/4" x 50mm SR)
CAP (20 x 20mm BLK)
ALLEN WRENCH (4mm)
1PC
4PCS
1PC
STEP 1
PAGE 3 OF 4
STEP 2
A
2
A
2
2
2
B
B
2
2
4
2
A
4
4
2
4
A
C
1
1
D
3
1
1
1
ANTI-TIPPING INSTALLMENT INSTRUCTIONS
PAGE 4 OF 4
FURNITURE TIPPING RESTRAINT
WARNING
Injury may result from tipping furniture.
This restraint may protect against tipping furniture.
Do not allow children to climb on furniture.
This restraint is not a substitute for proper adult supervision.
Failure to detach this restraint before moving the furniture
may result in injury and damage.
This tip restraint must be attached to a wall
stud using long screw enclosed.
STEP 1
Attach a bracket securely to the back top rail of the
furniture using short screw provided, through the
smaller hole.
STEP 2
Locate the other bracket on the wall over a wall
stud and two inches below the mounting bracket
secured to the back of the furniture. Attach the
wall stud using the long screw provided, through the
smaller hole.
STEP 3
Place the furniture into position so both mounting brackets are vertically in line. Lace the end of the
restraint strap through the larger hole in each mounting bracket. Bring both ends together and slide
the flat end through the locking end and draw it through until all slack is removed. Confirm that the
strap is securely laced and locked.
PAGE 3 OF 3
Loading...