ASSEMBLY INSTRUCTIONS
PAGE 1 OF 7
BOOKCASE
802603
REVISION 0: 11/12/2018
COASTER FINE FURNITURE
www.coastercompany.com
LEFT FRAME
ITEM : 802603
ASSEMBLY INSTRUCTIONS
www.coastercompany.com
PAGE 2 OF 7
A
ASSEMBLY TIME :
45 MINUTES
PARTS IDENTIFICATION
BOTTOM CROSSBARS
1PC
E
2PCS
RIGHT FRAME
B
SUPPORT BARS
C
TOP AND LOWER
D
CROSSBARS
1PC
2PCS
4PCS TOP SHELF
O SHAPE UPPER
F
FRAME
O SHAPE LOWER
G
FRAME
H
2PCS
2PCS
1PC
UPPER SHELF
ITEM : 802603
ASSEMBLY INSTRUCTIONS
www.coastercompany.com
PAGE 3 OF 7
I
1PC
SIDE SHELF
M
1PC
SMALL UPPER
J
SHELF
MIDDLE SHELF
K
SMALL LOWER
L
SHELF
1PC
1PC
1PC
SMALL SHELF
N
BOTTOM SHELF
O
LOWER SHELF
P
3PCS
1PC
1PC
HARDWARE IDENTIFICATION
CAP (20x20mm BLK)
SCREW (4x25mm SR)
BOLT (1/4" x 50mm SR)
ALLEN WRENCH (4mm)
8PCS
38PCS
28PCS
1PC
STEP 1
www.coastercompany.com
ASSEMBLY INSTRUCTIONS
ITEM : 802603
PAGE 4 OF 7
1
1
A
B
STEP 2
3
2
1
3
2
1
E
P
O
A
D
2
1
2
1
3
3
3
B
3
K
2
2
G
3
3
STEP 3
www.coastercompany.com
ASSEMBLY INSTRUCTIONS
ITEM : 802603
PAGE 5 OF 7
C
I
STEP 4
A
3
3
3
2
3
3
2
2
B
3
D
3
F
A
H
2
2
B
3
STEP 5
www.coastercompany.com
ASSEMBLY INSTRUCTIONS
ITEM : 802603
PAGE 6 OF 7
N
N
2
2
N
J
2
2
M
2
STEP 6
2
2
L
2
2
2
ANTI-TIPPING INSTALLMENT INSTRUCTIONS
PAGE 7 OF 7
FURNITURE TIPPING RESTRAINT
WARNING
Injury may result from tipping furniture.
This restraint may protect against tipping furniture.
Do not allow children to climb on furniture.
This restraint is not a substitute for proper adult supervision.
Failure to detach this restraint before moving the furniture
may result in injury and damage.
This tip restraint must be attached to a wall
stud using long screw enclosed.
STEP 1
Attach a bracket securely to the back top rail of the
furniture using short screw provided, through the
smaller hole.
STEP 2
Locate the other bracket on the wall over a wall
stud and two inches below the mounting bracket
secured to the back of the furniture. Attach the
wall stud using the long screw provided, through the
smaller hole.
STEP 3
Place the furniture into position so both mounting brackets are vertically in line. Lace the end of the
restraint strap through the larger hole in each mounting bracket. Bring both ends together and slide
the flat end through the locking end and draw it through until all slack is removed. Confirm that the
strap is securely laced and locked.
PAGE 3 OF 3
Loading...