Coaster 704417 Assembly Guide

REVISION 0 : 02/09/2015

REVISION 1 : 03/03/2015

704417

END TABLE

ASSEMBLY INSTRUCTIONS

COASTER FINE FURNITURE

www.coastercompany.com

PAGE 1 OF 3

B

1

2

3

4

5

6

7

www.coastercompany.com

PAGE 2 OF 3

ITEM :

704417

!

ASSEMBLY TIPS:

1. Remove hardware from box and sort by size

2. Please check to see that all hardware and parts are present prior to start of assembly.

3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.

Warning!

1. Don't attempt to repair or modify parts that are broken or defective. Please contact the
store immediately.

2. This product is for home use only and not intended for commercial establishment

ASSEMBLY INSTRUCTIONS

PARTS IDENTIFICATION

A

C

TABLE TOP WITH
DRAWER

TABLE LEG 4 PCS

SHELF

HARDWARE IDENTIFICATION

ALLEN WRENCH 1PC

BOLT 8PCS

LOCK WASHER

1 PC

1 PC

8PCS

NOTE : PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE ASSEMBLY PROCESS.

HOWEVER, MANUFACTURER DOES NOT PROVIDE THIS ITEM.

FLAT WASHER

CAM NUT 4PCS

PULL & SCREW 1PC

8PCS

4PCSCAM BOLT

STEP 1

STEP 2

Screw in cam bolt ( 6 ) to table leg ( B )

2.1) Place table top (A) upside down on soft surface.

Align and fasten 1pc of table leg (B) to table top (A)

using bolt (2), lock washer (3) and flat washer (4)

and fully tighten with Allen wrench (1)

2.2) Align & fix shelf ( C ) to the cam bolt (6) of table

leg (B) , as per diagram shown.

2.3) Align and fasten another piece of table leg (B) to

table top (A) using bolt (2), lock washer (3) &

flat washer (4) and fully tighten with Allen wrench

(1), with shelf ( C) fixed to the cam bolt (6) of

table leg (B) simultaneously.

STEP 3

STEP 4

3.1) Align and fasten the rest of 2pcs of table leg (B) to

Align and fasten pull to drawer front using screw ( 7) and

table top (A) using bolt (2), lock washer (3) & flat

fully tighten with Phillips head screw driver

washer (4) and fully tighten with Allen wrench (1),

( NOT INCLUDED ).

with shelf ( C) fixed to the cam bolt (6) of table

leg (B) simultaneously

3.2) Fasten shelf (C ) to table leg (B) using cam nut (5)

and fully tighten with Allen wrench ( 1 )

www.coastercompany.com

ITEM :

PAGE 3 OF 3

704417

ASSEMBLY INSTRUCTIONS