Page 1
PAGE 1 OF 9
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
REVISION 0: 09/28/2017
www.coastercompany.com
REVISION 1: 01/05/2018
Page 2
PAGE 2 OF 9
ASSEMBLY INSTRUCTIONS
www.coastercompany.com
ASSEMBLY TIPS:
1.Remove hardware from box and sort by size.
2.Please check to see that all hardware and parts are present prior to start of assembly.
3.Please follow attached instructions in the same sequence as numbered to assure fast and easy assembly.
Warning !
1.Don't attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
2.This product is for home use only and not intended for commercial establishments.
PARTS IDENTIFICATION
HARDWARE IDENTIFICATION
Z - B2 (BOX 2) - HARDWARE PACK
IS LOCATED IN 461084 (B2)
1PC
A
B
E
F
G
H
J
B1 (BOX 1)
B2 (BOX 2)
ROLL SLAT
(14PCS/SET)
2SETS
B3 (BOX 3)
N
LEFT UPPER BED END
RIGHT UPPER BED END
LEFT
LOWER BED END
FRONT UPPER SIDE RAIL
BACK UPPER SIDE RAIL
FRONT LOWER
SIDE RAIL
BACK LOWER
SIDE RAIL
BACK UPPER
GUARDRAIL
FRONT UPPER
GUARDRAIL
C
D
I
RIGHT
LOWER BED END
K
L
RIGHT LADDER
STILE
LEFT LADDER
STILE
M
LADDER STEP
1
2
3
4
5
6
7
9
WOOD DOWEL
LONG BOLT
ALLEN CAP SCREW
ALLEN WRENCH
METAL PIN
16PCS
24PCS
1PC
MEDIUM BOLT
8PCS
LONG WOOD SCREW
HALF ROUND NUT
8
METAL PLATE
3PCS
ASSEMBLY TIME 30 MINUTES
1PC
1PC
1PC
1PC
1PC
1PC
1PC
1PC
1PC
1PC
1PC
16PCS
4PCS
16PCS
6PCS
4PCS
10
11
SHORT WOOD SCREW
SHORT BOLT
4PCS
15PCS
Page 3
PAGE 3 OF 9
www.coastercompany.com
STEP 1:
UPPER BED END
ASSEMBLY INSTRUCTIONS
9
2
9
11
F
F
8
I
3
2
J
E
B
6
6
1
1
1
9
E
J
I
B
A
E
NOTE: LADDER CAN BE INSTALLED AT THE LEFT OR RIGHT SIDE OF THE BUNK
BED. BEFORE INSTALLING THE (J) FRONT UPPER GUARDRAIL, PLEASE DECIDE
THE LOCATION OF THE LADDER FIRST.
Page 4
LOWER BED END
1
6
2
9
G
H
1
PAGE 4 OF 9
www.coastercompany.com
STEP 2:
STEP 3:
ASSEMBLY INSTRUCTIONS
N
N
5
C
D
C
H
N
Page 5
PAGE 5 OF 9
www.coastercompany.com
STEP 4:
ASSEMBLY INSTRUCTIONS
N
N
7
N
5
STEP 5:
Page 6
PAGE 6 OF 9
www.coastercompany.com
STEP 6:
STEP 7:
ASSEMBLY INSTRUCTIONS
4
K
M
9
6
9
10
L
4
M
K
Page 7
PAGE 7 OF 9
www.coastercompany.com
ASSEMBLY INSTRUCTIONS ITEM: 461084 (B1 - B3)
STEP 8:
Complete
Page 8
PAGE 8 OF 9
www.coastercompany.com
ASSEMBLY INSTRUCTIONS
The length and width of the bunk mattress are as follow:
Length Width Thickness
Upper bunk 74"- 75" 37 1/2"- 38 1/2" 6" Maximum
Lower bunk 74"- 75" 37 1/2"- 38 1/2" 6" Maximum
Ensure thickness of mattress does not exceed 6” and there must be at least 5” from mattress
sleeping surface to top edge of guardrail.
SAFETY WARNING
1. Follow the information on the warnings appearing on the upper bunk end structure and on
the carton. Do not remove the warning label from bed.
2. Always use the recommended size mattress or mattress support or both to help prevent the
likelihood of entrapment or falls.
3. Surface of mattress must be at least 5 in. (127 mm) below the upper edge of guardrails.
4. Do not allow children under 6 years of age to use the upper bunk.
5. Prohibit more than one person on upper bunk.
6. Periodically check and ensure that the guardrail, ladder, and other components are in their
proper position, free from damage, and that all connectors are tight.
7. Do not allow horseplay on or under the bed and prohibit jumping on the bed.
8. Always use the ladder for entering and leaving the upper bunk.
9. Do not use substitute parts. Contact the manufacturer or dealer for replacement parts.
10. Use of a night light may provide added safety precaution for a child using upper bunk.
11. Always use guardrail on both long sides of the upper bunk. If the bunk bed will be placed next to
the wall, the guardrail that runs the full length of the bed should be placed against the wall to
prevent entrapment between the bed and wall.
12. The use of water or sleep flotation mattress is prohibited.
13. Keep these instruction for future reference.
STRANGULATION HAZARD:
14. Never attach or hang items to any part of the bunk bed that are not designed for use with the bed for
example, but not limited to hooks, belts, and jump ropes.
REPLACEMENT PARTS:
Replacement parts, including additional guardrails may be obtained from any COASTER
Furniture Dealer.
SIZE OF MATTRESS
!
!
Page 9
PAGE 9 OF 9
www.coastercompany.com
ASSEMBLY INSTRUCTIONS
Loading...