Page 1
300007FULL
FULL SIZE BED
ASSEMBLY INSTEUCTIONS
COASTER FINE FURNITURE
1 OF 4
2014-5-8
Page 2
ITEM: 300007FB1 ASSEMBLY INSTRUCTION
A
Headboard
1PC
HARDWARE PACKAGE
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size.
2. Please check to see that all hardware and parts are present prior to start of
assembly.
3. Please follow attached instructions in the same sequence as numbered to assure
fast & easy assembly.
warning
1. Don't attempt to repair or modify parts that are broken or defective please contact
the store immediately.
2. This product is for home use only and not intended for commercial establishment.
PARTS IDENTIFICATION
B
Headboard 1PC
Wood legs 2 PCS
HARDWARE PACKAGE
1
2
5*23*67mm Allen wrench 1 PC
Ø5/16 * Ø16 * Ø1.5 mm Flat washer 2 PCS
3
All above hardware pack is located in 300007F B1
Long bolt 2 PCS
2 OF 4
Page 3
ITEM: 300007FB2 ASSEMBLY INSTRUCTION
5
1 PC
Headboard corner bracket Right (facing)
PARTS IDENTIFICATION
B
C
D
E
F
Wood legs 2 PCS
Bed rail 2 PCS
Footboard 1 PC
Slat 3 PCS
Support leg 3 PCS
HARDWARE PACKAGE
DESCRIPTION FIGURE
Allen wrench 5*23*67mm
1 1 PC
Q'TY
2 Flat washer Ø5/16 * Ø16 * Ø1.5 mm 2 PCS
Long bolt
32 PCS
Headboard corner bracket - Left (facing)
41 PC
-
Footboard corner bracket
62 PCS
Flat washer Ø6.5 * Ø19 * Ø2 mm
7 18 PCS
Short bolt
8 18 PCS
Wood screw
9 6 PCS
Allen wrench 4*23*60mm
10 1 PC
All above hardware pack is located in 300007F B2
3 OF 4
Page 4
S
IT NEEDS TWO PERSONS AND TAKES ABOUT THIRTY MINUTES TO ASSEMBLE
STEP 1
THE ITEM.
TEP 1
STEP 2
Attach the wooden foot(B) to the headboard(A) and footboard(D)
Align and attach the left and right brackets (4 and 5) to the bed rails (C) using flat
washer (7) bolt (8) and tighten with allen wrench (10). Then align and attach the
footboard brackets (6) to the footboard (D) and bed rails (C) using flat washer (7) bolt
(8) and tighten with allen wrench (10). Finally hang the bed rails (C) to the headboard
(A). Now tighten all corner brackets.
STEP 3
Set up support legs on the slats first, then attach slats on the side rails using wood
screw(9) tighten with screw driver (not included) .
4 of 4
Loading...