206365
R
CHEST
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
www.coastercompany.com
PAGE 1 OF 3
REVISION 0 : 05/23/2017
ITEM : 206365
ASSEMBLY TIPS:
ASSEMBLY INSTRUCTIONS
1.Remove hardware from box and sort by size.
2.Please check to see that all hardware and parts are present prior to start of assembly.
3.Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.
Warning!
1.Don't attempt to repair or modify parts that are broken of defective. Please contact the store
immediately.
2.This product is for home use only and not intended for commercial establishment.
ASSEMBLY TIME 5 MINUTES
PARTS IDENTIFICATION
A. CHEST 1 PC
STEP 1
NOTE: PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE
ASSEMBLY PROCESS; HOWEVER MANUFACTURER DOES NOT
PROVIDE THIS ITEM.
A
STEP 1.1
STEP 2.2
COMPLETE ASSEMBLY
PAGE 2 OF 3
www.coastercompany.com
PARTS IDENTIFICATION
ANTI - TIPPING KIT
HARDWARE IDENTIFICATION
A. CHEST
1 SET
1. SHORT SCREW 1PC
2. LONG SCREW 1PC
3. CABLE TIE 1PC
4. 'L' BRACKET 2PCS
4
1
This tip restraint must be attached to a wall stud
using long screw enclosed.
STEP 1
Attach a bracket securely to the back top rail of the chest
using short screw provided, through the smaller hole.
Locate the other bracket on the wall over a wall stud and
two inches below the mounting bracket secured to the
back of chest. Attached to the wall stud using the long
screw provided, through the smaller hole
STEP 2
WALL
2
4
Place the chest into position so both mounting brackets are vertically in line. Lace the end of the restraint strap through
the larger hole in each mounting bracket. Bring both ends together and slide the flat end through the locking end and
draw it through until all slack is removed. Confirm that the strap is securely laced and locked.
STEP 3
3
4
4
www.coastercompany.com
PAGE 3 OF 3
Loading...