205325
CHEST
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
www.coastercompany.com
PAGE 1 OF 3
REVISION 0 : 12/22/2016
ITEM : 205325
ASSEMBLY INSTRUCTIONS
PAGE 2 OF 3
www.coastercompany.com
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
Warning!
1. Donˊt attempt to repair or modify parts that are broken or defective. Please contact the
store immediately.
2. This product is for home use only and not intended for commercial establishment.
HARDWARE IDENTIFICATION
A
MIRROR
B LEG
1PC
4PCS
1 WOOD DOWEL 4PCS
NOTE : PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN
THE ASSEMBLY PROCESS; HOWEVER MANUFACTURER
DOES NOT PROVIDE THIS ITEM.
PARTS IDENTIFICATION
ASSEMBLY TIME 10 MINUTES
CHEST
2 BOLT 4PCS
3 LOCK WASHER 4PCS
4 FLAT WASHER 4PCS
5 ALLEN WRENCH 1PC
STEP 1
A
STEP 1.2
B
3
2
5
4
STEP 1.1
B
1
COMPLETE
ANTI - TIPPING KIT
PAGE 3 OF 3
www.coastercompany.com
PARTS IDENTIFICATION HARDWARE IDENTIFICATION
A CHEST
1PC 6 SHORT SCREW 1PC
THIS TIP RESTRAINT MUST BE ATTACHED TO A WALL
STUD USING LONG SCREW ENCLOSED.
STEP 1
Attach a bracket securely to the back top rail of the chest
using short screw provided, through the smaller hole.
STEP 2
Locate the other bracket on the wall over a wall stud and two
inches below the mounting bracket secured to the back of
chest. Atttached to the wall stud using the long screw
provided, through the smaller hole.
7 LONG SCREW 1PC
8 CABLE TIE 1PC
9 L BRACKET 2PCS
WALL
STEP 3
Place the chest into position so both mounting brackets are vertically in line. Lace the end of the restraint strap through the
larger hole in each mounting bracket. Bring both ends together and slide the flat end through the locking end and draw it
through until all slack is removed. Confirm that the strap is securely laced and locked.
A
9
6
9
7
9
8
9
Loading...