205133
DRESSER
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
www.coastercompany.com
PAGE 1 OF 4
REVISION 0: 04/19/2017
ITEM:205133
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size.
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instructions in the same sequence as numbered to assure fast and easy assembly.
ASSEMBLY INSTRUCTIONS
Warning!
1.Don't attempt to repair or modify parts that are broken or defective. Please contact the
store immediately.
2.This product is for home use only and not intended for commercial establishments.
ASSEMBLY TIME 15 MINUTES
PARTS IDENTIFICATION
A
B
C
DRESSER
LEG
CENTER SUPPORT LEG
1PC
4PC
1PC
WITH LEVELER
HARDWARE IDENTIFICATION
1
2
BOLT
LOCK WASHER
12PCS
12PCS
3
4
NOTE: PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE ASSEMBLY PROCESS;
HOWEVER, MANUFACTURER DOES NOT PROVIDE THIS ITEM
FLAT WASHER
ALLEN WRENCH
PAGE 2 OF 4
12PCS
1PC
www.coastercompany.com
ITEM:205133
STEP 1
B
ASSEMBLY INSTRUCTIONS
4
STEP 2
1
2
3
C
C
STEP 3
COMPLETE
A
Adjustable leveler
PAGE 3 OF 4
www.coastercompany.com
1.1 Attach one of the mounting brackets securely to the back edge of the dresser.Use the short screw.
1.2 Determine where the dresser is to be placed and mark location on the wall for the mounting
bracket screw hole approximately 2"below the bracket mounted to the edge of the dresser.
1.3 Drill a 3/16" hole in the wall. Press the plastic anchor into the hole and gently tap until the
flange on the anchor is against the wall surface.
1.4 Position the bracket over the anchor and use the long screw to securely attach the bracket
to the wall.
1.5 Place the dresser so the bracket on the back edge is in line with the bracket on the wall.
1.6 Lace an end of the cable tie down through each bracket. Bring both ends together and slide
the beaded end of the cable tie through the keyhole shaped slot on the other end until snug.
Pull down on the beaded end until it snap locks into the keyhole slot.
1.7 To double lock return the beaded end back through the keyhole as shown.
1.8 Check to make sure the cable tie is securely laced and locked to the brackets.
WALL
ANTI - TIPPING KIT
PARTS IDENTIFICATION
A DRESSER 1 PC
HARDWARE IDENTIFICATION
56CABLE TIE
8
79PLASTIC ANCHOR
LONG SCREW
L - BRACKET
1 PC
2 PCS
SHORT SCREW
1 PC
1 PC
1 PC
5
9
6
8
7
PAGE 4 OF 4
www.coastercompany.com
A
Loading...