203485
R
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
CHEST
www.coastercompany.com
PAGE 1 OF 3
REVISION 0: 05/01/2014
ASSEMBLY INSTRUCTIONS
ASSEMBLY TIPS:
1 . Remove hardware from box and sort by size.
2 . Please check to see that all hardware and parts are present prior to start of assembly.
3 . Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.
Warning !
1 . Don't attempt to repair or modify parts that are broken or defective. Please contact the
store immediately.
2 . This product is for home use only and not intended for commercial establishment.
PARTS IDENTIFICATION
www.coastercompany.com
PAGE 2 OF 3
R
ITEM : 203485
A. 1 PCCHEST
STEP 1
Unscrew drawer pull from the back of drawer front using screw driver (NOT INCLUDED). Align and fasten drawer pull to
drawer front using screw and tighten with screw driver (NOT INCLUDED).
A
R
www.coastercompany.com
PARTS IDENTIFICATION
This tip restraint must be attached to a wall
stud using long screw enclosed.
ANTI - TIPPING KIT
A. CHEST 1 SET
HARDWARE IDENTIFICATION
1. 1 PC.SHORT SCREW
2. 1 PC.LONG SCREW
3. 1 PC.CABLE TIE
4. 2 PCS.L BRACKET
STEP 1
Attach a bracket securely to the back top rail of the
chest using short screw provided, through the
smaller hole.
STEP 2
Locate the other bracket on the wall over a wall
stud and two inches below the mounting bracket
secured to the back of chest. Attached to the wall
stud using the long screw provided, through the
smaller hole.
1
4
A
2
4WALL
WALL
4
3
4
STEP 3
Place the chest into position so both mounting brackets are vertically in line. Lace the end of the
restraint strap through the larger hole in each mounting bracket. Bring both ends together and slide
the flat end through the locking end and draw it through until all slack is removed. Confirm that the
strap is securely laced and locked.
PAGE 3 OF 3
Loading...