Coaster 202095 Assembly Guide

Page 1
REVISION 0 : 11/26/2013
202095
CHEST
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
www.coastercompany.com
PAGE 1 OF 2
Page 2
STEP 1
STEP 3
ANTI - TIPPING KIT
Attach a bracket securely to the back top rail of the chest using short
PARTS IDENTIFICATION HARDWARE IDENTIFICATION
This tip restraint must be attached to a wall stud using long screw enclosed.
screw provided, through the smaller hole.
1
1
2 LONG SCREW 1PC
3
4
STEP 2
Locate the other bracket on the wall over a wall stud and two inches below the mounting bracket secured to the back of chest. Attached to the wall stud using the long screw provided, through the smaller hole.
SHORT SCREW
CABLE TIE
L BRACKET
WALL
1PC
1PC
2PCS
2
4
4
Place the chest into position so both mounting brackets are vertically in line. Lace the end of the restraint strap through the larger hole in each mounting bracket. Bring both ends together and slide the flat end through the locking end and draw it through until all slack is removed. Confirm that the strap is securely laced and locked.
WALL
3
4
4
PAGE 2 OF 2
www.coastercompany.com
Loading...