202083
REVISION 0 : 07/18/2011
DRESSER
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
www.coastercompany.com
PAGE 1 OF 3
REVISION 1 : 09/22/2011
ITEM :
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size
2. Please check to see that all hardware and parts are present prior start of assembly.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
STEP 1 STEP 2
Unscrew the drawer pull from the back of drawer front with
screw driver (not included)
202083
Warning!
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
2. This product is for home use only and not intended for commercial establishment
Align and fasten drawer pull to drawer front using screw and
tighten with screw driver (not included)
ASSEMBLY INSTRUCTIONS
STEP 3
Complete
www.coastercompany.com
PAGE 2 OF 3
ANTI-TIPPING KIT
PARTS IDENTIFICATION
A DRESSER 1SET 1
STEP 1 STEP 2
Attach a L-bracket securely to the back top rail of
the dresser using short screw provided,
smaller hole.
through the
HARDWARE IDENTIFICATION
2
3
4
Locate the other bracket on the wall over a wall
stud and two inches below the mounting bracket
secured to the back of dresser.
the wall stud using the long screw
through the smaller hole.
SHORT SCREW
LONG SCREW
CABLE TIE
L BRACKET
1PC
1PC
1PC
2PCS
Attached to
STEP 3
Place the dresser into position so both L-brackets are vertically in line. Insert the end of the cable tie
through the larger hole in each L-bracket. Bring both ends together and slide the flat end through the
locking end and pull until tight.
PAGE 3 OF 3
www.coastercompany.com
Loading...