Page 1
PAGE 1 OF 4
130005
3PCS DINING SET
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
www.coastercompany.com
REVISION 0 : 06/19/2011
REVISION 1 : 09/13/2011
Page 2
ASSEMBLY INSTRUCTIONS
HARDWARE IDENTIFICATION
A TABLE TOP 1PC 1
WRENCH
1PC
B TABLE LEG 4PCS 2
HEX NUT
8PCS
C 2PCS 3
LOCK WASHER
8PCS
D 2PCS 4 FLAT WASHER 8PCS
E 4PCS 5 ALLEN WRENCH 1PC
F 4PCS 6 BOLT 16PCS
G 2PCS 7 BAREEL NUT 16PCS
H
CUSHIONGSEAT 2PCS 8
PAN HEAD SCREW
8PCS
9
DOWEL
8PCS
www.coastercompany.com
PAGE 2 OF4
ITEM :
130005
TOP & BOTTOM
BACK SLAT
RIGHT SIDE
FRAME
LEFT SIDE FRAME
FRONT & BACK
RAIL
MIDDLE BACK
SLAT
PARTS IDENTIFICATION
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size
2. Please check to see that all hardware and parts are present prior start of assembly.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
Warning!
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
2. This product is for home use only and not intended for commercial establishment
Page 3
ASSEMBLY INSTRUCTIONS
STEP 1 STEP 2
STEP 3 STEP 4
www.coastercompany.com
PAGE 3 OF 4
130005
Place table top upside down on soft suface, align and
fasten all legs to table top using bolt, lock washer and
flat washer and tighten with wrench.
Align and fasten back slats, front and back rails to right
side frame using bolt and barrel nut and tighten with
allen wrench.
Repeat step 3 for left side frame
ITEM :
Align and fasten back slats, front and back rails to
left side frame using bolt and barrel nut and tighten
with wrench
Page 4
ASSEMBLY INSTRUCTIONS
STEP 5 STEP 6
www.coastercompany.com
PAGE 4 OF 4
Align and fasten cushion seat to front and back rails using
screws and tighten with screw driver (Not provided).
130005
ITEM :
Insert dowels into side rails
Complete
STEP 7
Loading...