Coast PX45 User Manual

PX45 instructions

Battery Installation

Turn the end cap in a counter-clockwise direction to remove the cap.
Remove the battery cartridge.
Place three AAA batteries into the cartridge in the direction indicated on the cartridge.
Replace the cartridge in the light with the red end going in first.
Replace the tail cap and turn it clockwise to tighten it until it is fully closed.

Quick Cycle Switch Operation

This flashlight is equipped with COAST’s Quick Cycle Switch™, featuring high and low beams.

To activate the high beam from the off position, press the on/off switch until it clicks once, then release.
To activate the low mode, press the on/off switch until it clicks a second time, then release.
The light can also be operated in “momentary” mode. Momentary mode is activated by partially depressing the

on/off switch (less pressure than required for a full click). The momentary switch will cycle the light through the
high and low beam modes.

Any time the light is turned off for more than five seconds, the high/ low cycle will reset and the high beam will

be activated when the light is turned on again.

Pure Beam Twist-Focusing Optic

This flashlight is equipped with COAST’s Pure Beam™ Focusing Optic that allows the user to choose between a

broad flood beam and a focused Bulls-Eye Spot™ beam for long distance illumination.

To adjust the beam into the Bulls-Eye Spot™ mode, turn the front bezel of the light clockwise
To adjust the beam into the broad, flood light mode, turn the front bezel of the light counter-clockwise.