Coast HP314 User Manual

HP314 Instructions:

Battery Installation

Remove the rubber tail cap cover.
Turn the end cap in a counter-clockwise direction to remove the cap.
Place four D batteries into the light, the positive (+) pole on each battery should be inserted

first.

Replace the tail cap and turn it clockwise to tighten it until it is fully closed.

Quick Cycle Switch Operation

This flashlight is equipped with COAST’s Quick Cycle Switch™, featuring high, strobe and low beams.

To activate the high beam from the off position, press the on/off switch until it clicks once, then

release. Press the on/off switch until it clicks a second time to turn off the light.

To activate the strobe mode press the on/off switch until it clicks a third time, then release.

Press the on/off switch until it clicks a fourth time to turn off the light.

To activate the low mode, press the on/off switch a fifth time until it clicks. Press the on/off

switch until it clicks a sixth time to turn off the light.

The light can also be operated in “momentary” mode. Momentary mode is activated by

partially depressing the on/off switch (less pressure than required for a full click). The
momentary switch will cycle the light through the high, strobe and low beam modes.

Any time the light is turned off for more than five seconds, the high/ low cycle will reset and the

high beam will be activated when the light is turned on again.

Long Range Focusing Optic with Speed Focus

This flashlight is equipped with COAST’s Long Range Focusing Optic with Speed Focus™ that

allows the user to choose between a Broad View Flood Beam and a focused Accu-Spot beam for
long distance illumination.

To adjust the beam into the Accu-Spot mode, grip the rubber bezel ring on the front of the light

and slide the head of the light all the way forward.

To adjust the beam into the Broad View Flood Beam, slide the head of the flashlight back.

Accessories:

Shoulder Strap

The HP314includes a shoulder strap for carrying the light. To use the strap, slide the support

rings onto the body of the light, from the rear.

One ring should be positioned near the head of the flashlight. The second should be positioned

near the tail of the light.

Attach the strap to the support rings with the included clips.

Belt Ring

The included belt ring can be used to hang the HP314 from a belt.
Thread your belt (not included) through the nylon strap on the belt ring. Position the light in the

desired location on your waist – usually the left or right hip area.

Insert the tail of the light through ring.

Bezel Ring

The bezel ring comes installed on the light to provide grip when using the Long Range Focusing

Optic and provide extra impact protection.

Tail Cap Cover