10.3 Communications Regulation Information ............................................................167
5
Version 1.0.15
FCC Caution
1. The device complies with Part 15 of the FCC rules. Operation is subject to the following
conditions:
2. This device may not cause harmful interference, and this device must accept any
interference received, including interference that may cause undesired operation.
3. FCC RF Radiation Exposure Statement: The equipment complies with FCC RF radiation
exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance of 20 centimeters between the radiator
and your body.
4. This Transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
5. Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.
6
Version 1.0.15
Safe Seating Gestures
You should follow the manufacturer’s instructions for adjusting the backrest to fit your body
properly.
An adjustable chair that provides firm, comfortable support is best.
Adjust the height of the chair so your thighs are horizontal and your feet flat on the floor.
The back of the chair should support your lower back (lumbar region).
CE Statement of Conformity
Our product has been tested in typical configuration by Ecom Sertech Corp and was found to
comply with the essential requirement of “Council Directive on the Approximation of the Laws
of the Member States relating to Electromagnetic Compatibility” (89/336/EEC; 92/31/EEC;
93/68/EEC)
7
Version 1.0.15
Chapter 1 Introduction
1.1 Overview
11N Mini Router might be small in size, but is huge in functionality. It supports multiple
operation modes, including Access Point (AP) mode, Router mode, and WiFi AP mode. You
can switch among these modes easily by using its 3-way configuration switch.
8
Version 1.0.15
Features
y Small in size but huge in functionality; the world No.1 Mobile Router for traveler
y Three modes to be switched; Router, AP and WiFi AP
y WPS button provides not only an easy and secured wireless network but also a WDS
repeater in one push
yMultiple APs Supported; adds or limits the properties for classed SSID, increasing the
flexibility and efficiency of the network.
9
Version 1.0.15
1.2 Specifications
WAN Port 1 x 10/100 Mbps RJ45, with auto MDI/MDIX
Interface
Function
Others
LAN Port 1 x 10/100 Mbps RJ45, with auto MDI/MDIX
Wireless Built-in Mini PCI
Slide Switch Router / AP / WiFi AP mode exchange function.
Web-Base Windows IE / Linux Firefox / MAC Safari
WAN Protocol PPPoE / PPTP / Static IP/ Dynamic IP/ L2TP
WLAN
Routing UPnP / DHCP / DNS / WINS / DDNS
NAT Virtual Server / Virtual DMZ
Firewall MAC Filter / URL Filter / SPI / DoS Protection / IP Packet Filter
Operation
Requirement
Peak Gain of the
Antenna
WDS / WEP Key / WPA / WPA-PSK / WPA2 / WPA2-PSK / MAC Access
Control /Hidden SSID
Operating Temp. 0°C~45°C (32°F~113°F)
Storage Temp. -20°C~70°C (-14°F~158°F)
Operating Humidity 10% to 85% Non-Condensing
Storage Humidity 5% to 90% Non-Condensing
2dBi @ 2.45GHz
Application
Dimension 88mm (L) x 58mm (W) x 26.5mm (H)
Power Power Adapter DC5V/0.5A with mini-USB B type male connector
Note: 1. Firmware Upgrade available through download.
10
Version 1.0.15
1.2.1 Six Views of Product Appearance
Power Plug
Operation Mode
Switch
Reset Button
Ethernet Port
Power Adapt er DC5V/0.5A with mini-USB B type male connector
Router, AP, and WiFi AP operation mod es
Press “Reset” button over 10 seconds. When status indicator turns from
flashing to solid, the process is completed. All settings are back to default.
2 RJ-45 Ethernet 10/100 Ports
1.2.2 LED Indicator Status Description
Status
LED Indicator
STATUS Operation OK Green: Reset / Firmware updates in progress
LAN RJ-45 Plugged in Transmitting Data
WAN RJ-45 Plugged in Transmitting Data
WIRELESS & WPS Operation OK
POWER Operation OK Power on
Solid Flashing
Green: Transmitting Data
Orange: WPS enabled
1.3 System Requirements
11
Version 1.0.15
To begin with 11N Mini Router, you must have the following minimum system requirements. If
your system can’t correspond to the following requirements, you might get some unknown
troubles on your system.
XDSL/Cable Modem and broadband Internet Account.
One Ethernet (10 BASE-T or 10/100 BASE-TX) network interface card.
CP/IP and at least one web browser software installed (E.g.: Internet Explorer 5.0,
Netscape Navigator 7.x, Apple Safari 2.03 or higher version).
At lease one 802.11g (54Mbps) or one 802.11b (11Mbps) wireless adapter for wireless
mobile clients.
Recommended OS: Win2000 or WinXP / Linux.
1.4 WAN Network Plug and Play
WAN Type auto-detection:
When using Ethernet auto-connection:
¾ Auto-detection mode only applies on PPPoE, DHCP, PPTP and L2TP.
¾ Router will detect WAN type and load the settings from last time or display
corresponding page for user to input information.
¾If there is no setting from user, the router will load the default settings.
If there is no setting from user, it will detect ISP and load corresponding settings.
1.5 Get Your IP Automatically & Manually
After 11N Mini Router connected with your computer, please make sure your IP is in the
automatic IP position or you adjust it manually in order to activate the Internet network from
home to Internet. If you don’t know how to enter the settings, please follow the steps as
below.
Step 1. Go to St art>Settings> Network Connections and then select Local Area
Connection.
12
Version 1.0.15
Step 2. Click on Properties
Step 3. Double click on Internet Protocol (TCP/IP).
13
Version 1.0.15
Step 4-1. For getting IP automatically if you are one of the users under 11N Mini Router,
please skip Use the following IP address and then select Obtain an IP address
automatically and Obtain DNS server address automatically and then click on OK button.
Step 4-2. For getting IP manually in order to specify a Virtual Server, such as Print Server, FTP Server and so on, please skip Obtain an IP address automatically and then select Use
the following IP address. And the following default setting of 11N Mini Router should be
noted:
y IP Address: 192.168.1.10 (as your Print Server for example)
y Subnet Mask: 255.255.255.0
14
Version 1.0.15
yDefault Gateway: 192.168.1.1
Note: If you configure your computer’s IP Address manually, it needs to be on the same network segment.
For example:
z IP Address: 192.168.1.xxx (xxx can be any number between 2 and 253, but it can’t be
repeated, we use 100 to be the example.)
z Subnet Mask: 255.255.255.0
z Gateway: 192.168.1.1 (this is the IP address of 11N Mini Router in Router Mode)
z DNS: 192.168.1.1 (use 11N Mini Router’s IP address or on your own choice)
Note: IP address and Default gateway cannot be the same.
1.5.1 Network Testing
There are two ways to test your Network whether it can work on Internet or not. They are
“Testing with Internet Browser” and “Testing with Dos”.
1.5.2 Testing with Internet Browser
Open an Internet Browser, such as Internet Explore or Netscape. Input a valid web address
you like, for example,
enter. If the website appears, that means your Internet is working under normal situation.
http://www.yahoo.comin the web address blank and then press
15
Version 1.0.15
1.5.2.1 Testing with DOS (Windows XP Platform)
Step 1. Go to start -> Run.
Step 2. Input cmd in the blank, and then click OK button. The Command Prompt window
appears.
Step 3. Input ipconfig in the flashing area then press enter. You will get an IP Address
192.168.1.100, for example, and Default Gateway as 192.168.1.1.
16
Version 1.0.15
Step 4. Ping a legal WAN Address such as 192.168.1.1. If Internet works, it will show Reply
from 192.168.1.1: bytes = 32 time = 3ms TTL =64, for example.
If it can’t work, it will show Request timed out.
17
Version 1.0.15
Chapter 2 Hardware Installation
2.1 Diagram of Connecting Hardware to 11N Mini Router
11N Mini Router is a portable and convenient wireless solution for the traveling businessmen
delivering 802.11n wireless connectivity with a maximum wireless signal rate of up to
300Mbps. Use it in conference rooms, hotel rooms, or even at hotspots. The Wireless Pocket
Router/AP might be small in size, but is huge in functionality, supporting multiple operation
modes, including Access Point (AP) mode, Router mode, and WiFi AP mode. You can switch
among these modes easily by using 11N Mini Router's 3-way configuration slide switch.
Warning: Before sliding the switch modes, please power-off the router firstly. Moreover, please stay over 5
seconds between power-off / power-on condition.
2.1.1 Hardware Connection and Application for Router Mode
When 11N Mini Router switches to Router Mode, there will be each WAN and LAN port
existing, the administrator can do the Quick Setup including WAN Setup, LAN Setup,
Wireless Setup, Time Server Setup, Password Setup, Firewall Setup, QoS Setup.
18
Version 1.0.15
2.1.2 Hardware Connection and Application for AP Mode
Under AP Mode, it supports 2 LAN ports as Bridge, and user can connect to 11N Mini Router
via LAN port. The administrator can set up quickly, including LAN Setup, Wireless Setup,
Time Server Setup, and Password Setup.
2.1.3 Hardware Connection and Application for Wi-Fi AP Mode
As WiFi AP Mode, 11N Mini Router will be a bridge and supports a wireless LAN. The
administrator can set up quickly, including LAN Setup, Wireless Setup, Time Server Setup,
and Password Setup.
19
Version 1.0.15
Chapter 3 One Button Setup
The advanced One Button Setup provides users a simple way to set up the complicated
network. Instead of numbers of IPs to be memorized, you just need to fill in some necessary
information and then enjoy the secured internet by clicking the “Finished” button.
3.1 One Button Setup configuration for Router Mode
Step 1. Please switch to Router mode and plug in power.
The default UPnP of 11N Mini Router is ON.
20
Version 1.0.15
Step 2. Click the Internet Gateway Device to open the login page.
Step 3. Click One Button Setup on the left of the main menu under router mode.
21
Version 1.0.15
Time Zone Select: Select your time zone from the Time Zone drop-down list. Change Password: For changing password, please fill the password information into
the blank.
Device Name: Name your device here. The default is 11N_Mini_Router.
Note: System will automatically copy the last 6 numbers of this device’s MAC address after your device name.
WAN Interface Setup: Select the WAN Interface from the drop-down list.
WAN Type Setup: Please choose the access type. Wireless Setup: Fill in the ESSID if it is blank, and your prefer Encryption type. The
default is 11N_Mini_Router.
Finished: Click finished button to complete the setting.
3.2 One Button Setup configuration for AP Mode
22
Version 1.0.15
Step 1. Please switch to AP mode and plug in power.
Step 2. Click the Internet Gateway Device to open the login page.
Step 3. Click One Button Setup on the left of the main menu under AP mode.
23
Version 1.0.15
Time Zone Select: Select your time zone from the Time Zone drop-down list.
Change Password: For changing password, please fill the password information into
the blank.
Device Name: Name your device here. The default is 11N_Mini_Router.
Note: System will automatically copy the last 6 numbers of this device’s MAC address after your device name.
Wireless Setup: Define the SSID, and Encryption type.
Finished: Please click finished button to complete the setting.
3.3 One Button Setup configuration for WiFi AP Mode
Step 1. Please switch to WiFi AP mode and plug in power.
24
Version 1.0.15
Step 2. Click the Internet Gateway Device to open the login page.
Step 3. Click One Button Setup on the left of the main menu under WiFi AP mode.
25
Version 1.0.15
Time Zone Select: Select your time zone from the Time Zone drop-down list.
Change Password: For changing password, please fill the password information into
the blank.
Device Name: Name your device here. The default is 11N_Mini_Router.
Note: System will automatically copy the last 6 numbers of this device’s MAC address after your device name.
Wireless Site Survey Setting: Select the preferred AP for connection, and the
encryption type.
Extended Wireless Setup: Define the ESSID, and Encryption type.
Finished: Please click finished button to complete the setting.
26
Version 1.0.15
Note: One Button Setup is not completed unless users finish all settings and click Finished button.
27
Version 1.0.15
Loading...
+ 63 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.