CNB NB21-7MHR User Manual
MB12-7MH
Owner’s Manual
NB21-7MHR-6
Fusion IR Full HD Bullet IP Camera
NNBB2211--77MMHHRR--66 UUsseer
r
’
’
ss GGuuiiddee
2
Rev.1.4
Directions
Be careful not to cause any physical damage by dropping or throwing IP Camera. Especially keep
the device away from children.
Do not disassemble IP Camera. No After Service is assumed when disassembled.
Use only the power adapter provided with IP Camera.
Be careful to prevent moisture or water penetration into the unit. Particular attention is needed
when installing IP Camera. The screw holes for the installation screws and pipes should be
maintained tight during the whole life time of the product.
All the electrical connection wires plugging in the unit should be prepared so that water from the
outside cannot flow into the unit through the surface of the wires. Penetration of the moisture
through the wire for extended period can cause malfunction of the unit or deteriorated image.
CAUTION!
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
MB12-7MH
Owner’s Manual
The lightning flash with arrowhead symbol, within an equilateral triangle, is
intended to alert the user to the presence of uninsulated “dangerous voltage"
within the product's enclosure that may be of sufficient magnitude to constitute
a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to
the presence of important operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
THE GRAPHIC SYMBOLS WITH SUPPLEMENTAL MARKING ARE ON THE BOTTOM OF THE SYSTEM.
"WARNING-TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN OR MOISTURE"
NNBB2211--77MMHHRR--66 UUsseer
r
’
’
ss GGuuiiddee
3
Rev.1.4
CAUTION!
Changes or modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment.
Regulatory Notice
This equipment has been tested and found to comply with limits for a Class of digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at their own
expense.
NNBB2211--77MMHHRR--66 UUsseer
r
’
’
ss GGuuiiddee
4
Rev.1.4
11..22..22.
.
SSppeecciiffiiccaattiioon
n
Contents
1. Introduction .................................................................................................................................................... 5
1.1. Overview ............................................................................................................................................... 5
1.2. Features & Specification ....................................................................................................................... 6
1.2.1. FFeeaattuurreess
1.3. Applications of IP Camera .................................................................................................................... 9
2. Product Description .................................................................................................................................... 10
2.1. Contents .............................................................................................................................................. 10
2.2. Camera mount configuration............................................................................................................... 10
2.3. Product Preview .................................................................................................................................. 11
2.4. Physical description ............................................................................................................................ 11
2.4.1. External View ............................................................................................................................ 11
2.4.2. Dimension ................................................................................................................................. 12
2.4.3. External Connector ................................................................................................................... 12
2.4.4. Factory Default Switch .............................................................................................................. 12
2.5. Functional Description ........................................................................................................................ 13
3. On Site Installation ...................................................................................................................................... 15
4. Getting Started ............................................................................................................................................. 17
...................................................................................................................................... 6
................................................................................................................................ 6
4.1. PC Requirement ................................................................................................................................. 17
4.2. Quick Installation Guide ...................................................................................................................... 17
4.2.1. Connect PC and IP Camera to network. .................................................................................. 17
4.2.2. Install IP installer and set IP parameters on IP Camera ........................................................... 18
4.2.3. Remote video connection to IP Camera ................................................................................... 21
4.2.4. Additional settings through connection to the Admin Page ...................................................... 22
5. Troubleshooting ........................................................................................................................................... 23
5.1. No power ............................................................................................................................................. 23
5.2. Cannot connect to the Video ............................................................................................................... 23
5.3. Windows 7 .......................................................................................................................................... 24
5.4. Technical Assistance ........................................................................................................................... 25
Appendix A – Important Notice in Exchanging SD Card (Micro SD) ......................................................................... 26
NNBB2211--77MMHHRR--66 UUsseer
r
’
’
ss GGuuiiddee
5
Rev.1.4
1. Introduction
1.1. Overview
The product is multi-codec (H.264, MJPEG) IP camera (or network camera) built with embedded software and
hardware technology. It enables real time transmission of synchronized video up to 1,080P and audio data.
Remote clients can connect to IP Camera for the real time video/audio data through various client solutions
running on PC or smart device. Real time 2-way communication is available through bidirectional audio
communication feature.
Dark Hunter technology is the most optimized solution for indoor and outdoor surveillance in low-light conditions
by using superior CMOS sensor with low-light sensitivity ISP sensor.
Furthermore, it can get much vivid image using Super IR LED in extremely low light conditions compared with
using conventional IR LED.
Designed to be a stand-alone streaming audio & video transmission device, the product can be applied to
various application area such as video security, remote video monitoring, distance education, video conference
or internet broadcasting system.
Vandal proof and weather proof housing will extend the application area to harsh environment of wide
temperature range. Embedded PoE (Power of Ethernet, IEEE 802.3af) will enable the owner to reduce TCO
(Total Cost of Ownership) by reducing on-site wiring works for the installation.
NNBB2211--77MMHHRR--66 UUsseer
r
’
’
ss GGuuiiddee
6
Rev.1.4
11..22..22.. SSppeecciiffiiccaattiioonn
Camera
Image sensor
Progressive scan 1/3 inch CMOS 2M pixels
Full resolution
1,920 x 1,080 pixels (Full HD)
Sync System
Internal
Lens
6mm Fixed
Day & Night
AUTO, DAY, NIGHT
Sensitivity
Color : to 0.04Lux, B/W : 0Lux(IR ON)
Back Light Compensation
ON / OFF
White Balance
ATW(2.000K ~ 10,000K) / MANUAL / PUSH
Exposure
DC / ESC
WDR
ON / OFF
3D-DNR
0 ~ 20
Dark Hunter
AUTO ON (Max. x32) / OFF
Privacy Mask
ON / OFF (1 Programmable Zone)
Motion Detection
ON / OFF (3 Programmable Zone)
Digital Zoom
X1 ~ X12
1.2. Features & Specification
1.2.1. FFeeaattuurreess
H.264MP IP Camera
Fusion IR Full HD Bullet IP Camera
1/3” Progressive scan CMOS Sensor
Dual-Codec (H.264MP/MJPEG)
Progressive scan megapixel (2M CMOS)
Multi profile streaming
(5 different streams per Resolution, Frame, Rate, Codec)
Digital PTZ, video crop
Analog video output (CVBS)
Built-in standard PoE
Two-way audio communication
Dark Hunter + Super IR LED
Compact design & Easy installation
Vandal proof, Weather proof (IP66)
NNBB2211--77MMHHRR--66 UUsseer
r
’
’
ss GGuuiiddee
7
Rev.1.4
Mirror
H / V / Rotate
DEFOG
ON / OFF
OSD
BUILT IN
Super IR LED
2EA
Video
Compression method
Simultaneous Dual Codec (H.264MP / MJPEG)
Resolution
1,920 x 1,080@30fps
Multi-Profile Streaming
- 5 simultaneous video profiles
- Select the codec type, resolution and frame rates for each profile.
Intelligent Bit-Rate Control
Hybrid Bit Rate control (VBR+CBR)
PTZ
Digital PTZ & Video crop
Image Setting
Text overlay, Privacy mask, De-interlace filter
Motion detection
3 regions
Audio
Mono Upstream
32Kbps G.726 ADPCM, 64Kbps 16bit μ-law PCM ~ MIC/Line-in
Mono Downstream
64Kbps 16bit μ-law PCM ~ Line-out
Network
Network Protocol
- IPv4, TCP/IP, UDP, IGMP, ICMP, ARP, RARP, PPPoE, RTCP
- RTP, RTSP, SDP, HTTP, SMTP, FTP, DHCP, UPnP
- NTP, DNS, DynDNS
Dynamic IP
Supported
Security
- User ID & Password protection, IP address filtering
- Digest Authentication, User Access Log
Streaming method
- RTSP streaming with proprietary format for control information
- standard RTSP streaming
- HTTP streaming
- Onvif Profile-S
External Terminals
LAN
10/100BaseT LAN (auto MDIX)
Analog output
1 channel D1 CVBS output of the encoding video
Alarm input / output
Alarm I/O (1 Sensor input & 1 Relay output)
Factory Reset
Supported
Other
MIC, Line in / Line out / DC 12V in
Installation
Standard PoE
IEEE802.3af Supported
System Integration
Intelligent Video
Motion Detection
NNBB2211--77MMHHRR--66 UUsseer
r
’
’
ss GGuuiiddee
8
Rev.1.4
Alarm Triggers
Motion Detection + Sensor Input + Audio Detection
Alarm Events
Video file upload(FTP), Still Image transmission(Email), Relay output
Alarm Buffer (Audio/Video)
Configurable Pre-alarm (5~15 sec) & Post-alarm (10~60 sec)
Operating Environment, Power, Dimensions
Operating Temperature
-10C ~ 50C
Operation Humidity
8 ~ 80% RH
Power
DC 12V, 0.6A
Dimensions(W x H x D)
Ø 99mm x 252.7mm
Weight
1.1kg
Casing
AL, PC, IP66
Approvals
FCC, CE, KC
Package information
IP camera, CD (User’s guide, Software…)
Client Software
NVR2
64ch (free of charge)
Mobile
Android, iOS (free of charge)
Optional Items
Local storage
Micro SD card
Adapter
DC 12V, 1.5A
Loading...