CNB MP258VD User Manual
USER INFORMATION:
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION!
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Explanation of two Symbols
The lightning flash with arrowhead symbol, within an equilateral
triangle, is intended to alert the user to the presence of un-insulated
"dangerous voltage" within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to
alert the user to the presence of important operating and maintenance-
THE GRAPHIC SYMBOLS WITH SUPPLEMENTAL MARKING ARE ON THE BOTTOM
OF THE SYSTEM.
"WARNING-TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT
TO RAIN OR MOISTURE"
(servicing) instructions in the literature accompanying the appliance.
PRECAUTION:
!
When this camera is installed near wireless communication devices
that emits strong electromagnetic field, irregularity such as noise
on the monitor may appear.
This equipment has been tested and found to comply with limits for a
Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct
the interference at their own expense.
SPECIFICATIONS:
CCD Color Type
Signal System
Scanning System
Scanning Frequency (H)/(V)
Image Sensor
Total Pixels No.
S/N Ratio
Resolution
Lens
Focus
Sensitivity
Electronic Shutter
AGC / BLC
Input/Output Connector
Power Consumption
CCD B/W Type
Scanning System
Scanning Frequency (H)/(V)
Image Sensor
Total Pixels No.
S/N Ratio
Resolution
Lens
Focus
Min, Illumination
Electronic Shutter
Input/Output Connector
Power Consumption
NTSC : 525 Lines PAL : 625 Lines
15.734kHz / 59.94Hz 15.625kHz / 50Hz
410K [Normal: 270K] 470K [Normal: 320K]
1/60~100,000 Sec. 1/50~100,000 Sec.
15.734kHz / 59.94Hz 15.625kHz / 50Hz
768(H)x494(V) [Normal:510(H)x492(V)] 752(H)x582(V) [Normal:500(H)x582(V)]
0.2 Lux(High) / 0.1 Lux(Normal) : F1.2, 20IRE
1/60~100,000 Sec. 1/50~100,000 Sec.
2 : 1 Interlace
1/3 inch SONY IT CCD
More than 48dB
480 TV Lines / 380 TV Lines
Fixed Lens / Pin Hole Lens
Manual
0.3 Lux(High) / 0.1 Lux(Normal)
On / Off Selectable
Power(Red Jack), Video(Yellow Jack)
DC 12V (DC 9V~15V) / 3W (Max)
ver.0604E
P/N:3810-0073B
EIA CCIR
2 : 1 Interlace
1/3 inch SONY IT CCD
46dB (AGC Off)
570 TV Lines / 380 TV Lines
Fixed Lens / Pin Hole Lens
Manual
Power(Red Jack), Video(Yellow Jack)
DC 12V (DC 9V~15V) / 1.5W
32x32
CCD Camera Miniature
specialty
MiniatureDigital DSP
camera
LENS
.Fixed
.Pin Hole
1/3" SONY CCD
.COLOR
CCD
.B/W
INSTALLATION:
CONNECTION:
DC 12V Power Source
#
1
#
2
Video
(Yellow)
Power
(
Red
This manual explains the installation and operating method for the
color dome camera. Before installation, make sure you are familiar
with this product's special features and proper operating technique.
• The wire is polarized.
Video Output
GND
)
(DC 12V/ Over 0.3A Power Adapter)
※
Recommendable
Power Supply
• Use DC 12V power source.
Power(+)
GND
No.
#1
#2
Function
Video Output
Power Input
Terminal Color
Yellow
Red
DC12V(10V~15V),
Design and specifications
are subject to change
without notice.
Remark
1.0 Vp-p
COMPOSITION:
Own er's
Man ual
Wall Mounting
Bracket Screw
Screw
Dimensions(mm):
Fixed Lens
39.0
37.0
37.0
Miniature
Camera
Wall
Bracket
32.25
24.75 2.35
Pin Hole Lens
20.17 2.35
TO REDUCE THE RISK
OF ELECTRIC SHOCK DO
NOT REMOVE COVER.
NO
L H
BLC
BLC
1
OFF
ON
AGC
AGC
2
L H
OFF
ON
DC 12V
GND
V-OUT
DC 12V
GND
V-OUT
Loading...