CNB MP1310VD User Manual

USER INFORMATION:
CAUTION
DO NOT OPEN
CAUTION!
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Explanation of two Symbols
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance-
THE GRAPHIC SYMBOLS WITH SUPPLEMENTAL MARKING ARE ON THE BOTTOM OF THE SYSTEM.
"WARNING-TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN OR MOISTURE"
(servicing) instructions in the literature accompanying the appliance.
PRECAUTION:
!
When this camera is installed near wireless communication devices that emits strong electromagnetic field, irregularity such as noise on the monitor may appear.
This equipment has been tested and found to comply with limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their own expense.
38 x 38 Board
SPECIFICATIONS:
Signal System Scanning System Scanning Frequency (H) Scanning Frequency (V) Image Sensor Total/Effective Pixels No. S/N Ratio Resolution Video Output Level Lens Focus Sync. System Sensitivity Electronic Shutter White Balance AGC / BLC Flickerless Input/Output Connector Power Consumption
Design and specifications are subject to change without notice.
NTSC : 525 Lines PAL : 625 Lines
2 : 1 Interlace
15.734kHz 15.625kHz
59.94Hz 50Hz 1/3 inch SONY IT CCD
410K / 380K 470K / 440K
More than 48dB
550 TV Lines / 480 TV Lines / 380 TV Lines
1.0 Vp-p (75 Ohms, composite)
Vari-focal Lens / Fixed Lens / Pin Hole Lens
Manual Internal
0.3 Lux (High) / 0.1 Lux (Normal)
1/60~100,000 Sec. 1/50~100,000 Sec.
Auto On / Off Selectable On / Off Selectable
Power (Red Jack), Video (Yellow Jack)
DC 12V (DC 9V~15V) / 3W (Max)
ver.0604E
P/N:3810-0020C
38x38
CCD CameraColor Miniature
ColorDigital DSP
cameracolor
LENS
.Vari-focal .Fixed .Pin Hole
1/3" SONY CCD
CCD COLOR
INSTALLATION:
CONNECTION:
DC 12V Power Source
#
1
#
2
Video
(Yellow)
Power
(
Red
This manual explains the installation and operating method for the
color dome camera. Before installation, make sure you are familiar
with this product's special features and proper operating technique.
• The wire is polarized.
Video Output
GND
)
Recommendable
Power Supply
• Use DC 12V power source.
Power(+)
GND
No.
#1
#2
Function
Video Output
Power Input
Terminal Color
Yellow
Red
(DC 12V/ Over 0.3A Power Adapter)
Remark
1.0 Vp-p
DC12V(10V~15V),
3W(Max)
COMPOSITION:
Own er's
Man ual
Wall Mounting
Bracket Screw
Screw
Dimensions(mm):
43.0
43.0
Miniature
Camera
Wall
Bracket
Vari-focal Lens
27.8 3.4
Fixed Lens
35.3
27.8
Pin Hole Lens
24.8 3.4
DAMP DAMP DRIVE
GND
V-OUT
DC LEVEL
GND
DC 12V
P/N:3310-0018C
NO
1 2
3
4
BLC
AGC
FL
ALC
L
L
ON
OFF
ON
BLC
AGC
FL
H
H
ELC
OFF
ON
OFF
3.4
DAMP DAMP DRIVE
GND
V-OUT
DC LEVEL
GND
DC 12V
P/N:3310-0018C
NO
1 2
3
4
BLC
AGC
FL
ALC
L
L
ON
OFF
ON
BLC
AGC
FL
H
H
ELC
OFF
ON
OFF
DAMP DAMP DRIVE
GND
V-OUT
DC LEVEL
GND
DC 12V
P/N:3310-0018C
NO
1 2
3
4
BLC
AGC
FL
ALC
L
L
ON
OFF
ON
BLC
AGC
FL
H
H
ELC
OFF
ON
OFF
Loading...