CNB LXC1050IR User Manual
Network
W
eatherproof
Camera
LXC1050IR
LLXXCC11005500IIRR IInnssttaallllaattiioonn MMaannuuaall
Directions
Be careful not to cause any physical damage by dropping or throwing LXC1050IR. Especially
keep the device out of reach from children.
Do not disassemble LXC1050IR. No After Service is assumed when disassembled.
Use only the power adapter provided with LXC1050IR.
Be careful to prevent moisture or water penetration into the unit. Particular attention is
needed when installing LXC1050IR. The screw holes for the installation screws and pipe
should be maintained water tight during the whole life time of the product.
All the electrical connection wires running into the unit should be prepared so that water from
the outside cannot flow into the unit through the surface of the wires. Penetration of the
moisture through the wire for extended period can cause malfunction of the unit or
deteriorated image.
Note
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generate, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into and outlet on a circuit different from that to which
the receiver is connected
Consult the dealer or an experienced radio/TV technician for help.
Caution
Any changes or modifications in construction of this device which are not explicitly
approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
Rev.1.1 (Sep. 2014) 2
LLXXCC11005500IIRR IInnssttaallllaattiioonn MMaannuuaall
Contents
1. Introduction .............................................................................................................................................. 4
1.1. Overview ............................................................................................................................................. 4
1.2. Specification ........................................................................................................................................ 5
1.3. Applications of LXC1050IR .................................................................................................................. 6
2. Product Description ................................................................................................................................. 7
2.1. Contents ............................................................................................................................................. 7
2.2. Product Preview .................................................................................................................................. 7
2.3. Physical description............................................................................................................................. 8
2.3.1. External View ............................................................................................................................ 8
2.3.2. Dimension ................................................................................................................................. 8
2.3.3. External Connector .................................................................................................................... 9
2.3.4. BRACKET ASS’Y .................................................................................................................... 10
3. On Site Installation ................................................................................................................................. 11
4. Getting Started ....................................................................................................................................... 12
4.1. PC Requirement................................................................................................................................ 12
4.2. Quick Installation Guide ..................................................................................................................... 12
4.2.1. Connect PC and LXC1050IR to network. ................................................................................. 12
4.2.2. Install IP installer and set IP parameters on LXC1050IR .......................................................... 13
4.2.3. Remote video connection to LXC1050IR ................................................................................. 16
4.2.4. Additional settings through connection to the Admin Page ....................................................... 17
5. Trouble Shooting ................................................................................................................................... 18
5.1. No power is applied ........................................................................................................................... 18
5.2. Cannot connect to the Video ............................................................................................................. 19
5.3. Windows Vista or Windows 7............................................................................................................. 20
5.4. Technical Assistance ......................................................................................................................... 23
Rev.1.1 (Sep. 2014) 3
LLXXCC11005500IIRR IInnssttaallllaattiioonn MMaannuuaall
1. Introduction
1.1. Overview
LXC1050IR is multi-codec (H.264, MJPEG) IP camera (or network camera) built with embedded software and
hardware technology. It enables real time transmission of video of up to 1080P. Remote clients can connect to
LXC1050IR for the real time video data through various client solutions running on PC or smart device.
LXC1050IR is specialized in video transmission which economic and practical products removing sensor, replay,
etc and the videos can be only available in the field and place where needed.
Embedded PoE (Power over Ethernet, IEEE 802.3af) will enable the owner to reduce TCO (Total Cost of
Ownership) by reducing on-site wiring works for the installation.
Rev.1.1 (Sep. 2014) 4
LLXXCC11005500IIRR IInnssttaallllaattiioonn MMaannuuaall
1.2. Specification
Camera
Image sensor Progressive scan 1/2.9 inch CMOS 2.0M pixels
Full resolution 1,920 x 1,080 pixels (Full HD)
Min. illumination 0.2Lux (Color, DSS On), 0.00 Lux (IR LED On)
S/N Ratio 50dB or more
White Balance Auto
DSS Supported
WDR Off/ON
Lens Built-in Fixed Mega Pixel Lens, f=4mm, F2.0
Day & Night ICR(CDS Type)
IR LED 24EA(850nm, 45°) Max. 20m
Video
Compression method Simultaneous Dual Codec (H.264 / MJPEG)
Resolution 1920x1080@30fps
Multi-Profile Streaming
Intelligent Bit-Rate Control Hybrid Bit Rate control (VBR+CBR)
Image Setting Text overlay, Privacy mask
Motion detection 3 regions
Network
Network Protocol
Dynamic IP Supported (through management server)
Security
Streaming method
- 3 simultaneous video profiles
- Select the codec type, resolution and frame rates for each profile.
- IPv4/v6, TCP, UDP, IGMP, ICMP, ICMPv6, ARP, RARP, PPPoE, RTCP
- RTP, RTSP, SDP, HTTP, HTTPS, SMTP, FTP, DHCP, UPnP
- NTP, DNS, DynDNS, SOCKS
- User ID & Password protection, IP address filtering
- HTTPS encryption, Digest Authentication, User Access Log
- RTSP streaming with proprietary format for control informations
- Standard RTSP streaming
- HTTP streaming
External Terminals
LAN 10/100BaseT LAN
Power DC 12V input
Factory Reset Supported
Rev.1.1 (Sep. 2014) 5
LLXXCC11005500IIRR IInnssttaallllaattiioonn MMaannuuaall
Alternate Power
Standard PoE IEEE802.3af Supported
Alarm & Event
Intelligent Video Motion Detection
Alarm Triggers Intelligent Video
Alarm Events Video file upload(FTP), Still Image(Email)
Alarm Buffer (Video) configurable Pre-alarm (5~10 sec) & Post-alarm (10~30 sec)
Client Software
NVR2 64ch@D1 (free of charge)
Mobile App. Android, iOS (free of charge)
Miscellaneous
Operating Temperature -10C~50C
Operation Humidity 8~80% RH
Power DC 12V, Max 5W
Dimensions(W x H x D) 62mm(2.44”) x 62mm(2.44”) x 124.3mm (4.89”)
Weight Camera : 375g, Bracket : 55g
Casing ABS, White
Approvals FCC, CE, KCC, RoHS
Package information IP camera, CD (User’s guide, Software…)
Optional Items
Adapter DC 12V, 2A
1.3. Applications of LXC1050IR
Small Office, Home environment, Personal user.
Security surveillance (buildings, stores, manufacturing facilities, parking lots, banks, government facilities,
military, etc.)
Remote monitoring (hospitals, kindergartens, traffic, public areas, etc.)
Weather and environmental observation
Rev.1.1 (Sep. 2014) 6
LLXXCC11005500IIRR IInnssttaallllaattiioonn MMaannuuaall
2. Product Description
2.1. Contents
The product package contains followings :
Contents Description Remarks
LXC1050IR IP camera LXC1050IR main unit
Accessories
CD Software & User’s Guide
Bracket Bracket
2.2. Product Preview
LXC1050IR IP-Installer CMS Software (NVR2)
Screws (3 pieces of 1 type),
L-type wrench 1EA
PC software to view and record the
IP Camera
PC software to allocate an IP
address to the IP Camera
streaming data transmitted from IP
camera.
(Simultaneous support of up to 64
IP cameras@D1)
Rev.1.1 (Sep. 2014) 7
Loading...