CMR Electrical DTS Installation And Operation Manual

CMR Electrical Ltd
BoltonHouse
Five Chimneys Lane
Hadlow Down
East Sussex
TN22 4DX
Tel: [phone]

Water Leak Detection Sensor

Type DTS

for Drip Trays

Installation and Operation

Manual

2

Installation

The detection sensor is susceptible to damage and should not be fitted to areas where it is likely to be
walked on. Place the sensor on the drip tray so that the rubber feet are in contact with the tray.

Sensor wiring

Red

Black

Yellow

Blue

Liveor+supplyvoltage

Nor0Vsupplyvoltage

VoltFreeContact

RedWire= 12-24VACliveor 13-24VDC+

BlueWire= 12- 24VACNeutralor 13- 24VDCnegative

BlackWire=Volt freeContact common

YellowWire=VoltFreeContact NormallyOpen, Close inalarm

Connections

The signal cable should be terminated between the sensor and the main Alarm/BMS in the following
manner.

Connection to Signal Cable Signal cable wire

colour
+VDC/AC Red
0VDC/AC Blue

Contact N/O Yellow
Contact N/O Black

IP Rating

Rated at IP68, the sensor is fully potted and therefore can be submerged in water without damage.

Size

64mm

25mm

44mm

Signal Cable

Drip Tray

DTS Sensor

Rubber Feet