BATH CONTROL SYSTEM
OPERATING INSTRUCTIONS
TM
Your whirlpool bathtub has been equipped with Electronic Controls to provide
features that allow you to customize your bathing experience to your individual
preference. Please familiarize yourself with the features and operating
instructions below in order to maximize the enjoyment you receive from your
bath. These operating instructions should be used in conjunction with the other
instructions and warnings provided with your whirlpool bathtub in order to fully
understand and safely utilize the bathtub.
CONTROL PAD LAYOUTS
TABLE OF CONTENTS
1. OPERATING INSTRUCTIONS
2. TROUBLESHOOTING & FAQ
Power
Power
Instructions for Controller Heads:
26400-100-110
26400-102-100
26406-000-103 (Circular Controller – No Lock)
26406-002-103 (Circular Controller – No Lock)
1117ab
Pump
Light
Lock
Pump
Light
®
WWW.CMP.COM
1. OPERATING INSTRUCTIONS
1. Power (Activate System)
a. Tap Power button to turn ON control head.
b. Tap Power button again to turn OFF.
2. Pump
a. Tap Pump button to turn ON.
NOTE: If water level is too low, pump will not activate.
b. Tap Pump button again to turn OFF.
3. Light
a. Press and hold Light button ~2 seconds to turn light ON.
b. Tap Light button to cycle through light colors.
c. Press and hold to turn light OFF.
4. Lock (not featured on round control heads)
a. Press and hold Lock button for ~2 seconds to activate “Lock” feature.
b. This will prevent the user from accidently activating a button once the
system is on.
c. Press and hold to turn lock OFF.
2. FAQ & TROUBLESHOOTING
1. What do I do if the Light does not turn on?
a. Check the electrical connections to the Light.
2. What do I do if the Pump does not turn on?
a. Check water level.
b.Pumpwillnotengagewithoutasucientwaterlevel.
3. What do I do if the Pump and/or Light functions are not working when control head is activated?
a. Check if Lock function is engaged.
For all other technical issues please contact CMP technical support through our website
www.c-m-p.com or by phone at 800-733-9060.
2
Loading...