CMP Huron Installation Instructions Manual

Huron (LDAL Cable Cleat)Huron

(LDAL Cable Cleat)

Features

• Third party certification to IEC 61914:2009

• 5000 series aluminium

• 19 - 128mm in 23 sizes for trefoil formation /

application

• Operating temperature of -50°C to +60°C

• Low Smoke & Fume (LSF) liners as standard

• One or Two M10 fixing design

www.cmp-products.com

Cleat Installation
Instructions

FI530 REV 0

CMP Cleat Installation Instructions

1. Place the cable cleat in desired

location on mounting surface and
unhinge the cable cleat.

2. Insert base booster if required.

4. Tighten down to specified

torque rating of 8Nm (2 bolt option
pictured).

6. Using supplied mouthpiece

fittings, tighten down to no more
than 8Nm with 19mm nut spanner.

3. Secure cleat to the mounting surface

using 1x M10 bolt (3a) or 2 x M10 bolts (3b),
adding a washing and nut on both sides.

5. Place the cable into the cleat

and pull the hinged arm over the
cables.

Nut
Spacer

Note: Cleat marking can be found on hinged arm

Booster

(3a)

(3b)