Vertical(V) 321.7 322.2 322.7 mm
Depth(D) - - 21 mm
Weight - - 2,200 g
5/24
Version 3.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
1. ABSOLUTE MAXIMUM RATINGS
1.1 ABSOLUTE RATINGS OF ENVIRONMENT
Item Symbol
Storage temperature Tst -20 +60 ºC (1)
Operating temperature (Ambient Temperature) Top 0 +50 ºC (1),(2)
Shock(non-operating) Snop - 30 G (3),(5)
Vibration(non-operating) Vnop - 1.5 G (4),(5)
Note (1) Temperature and relative humidity range is shown in the figure below.
(a) 90 %RH Max. (Ta Љ 40 ºC).
(b) Wet-bulb temperature should be 39 ºC Max. (Ta > 40 ºC).
(c) No condensation.
Note (2) The temperature of panel surface should be 0 ºC Min. and 60 ºC Max.
Note (3) 6ms, half sine wave, 1 time for ± X, ± Y, ± Z.
Note (4) 10 ~ 500 Hz, 0.5 Hr each X, Y, Z.
Note (5)At testing Vibration and Shock, the fixture in holding the module has to be hard and rigid
enough so that the module would not be twisted or bent by the fixture.
www.panelook.com
Min. Max.
Values
Dcc No.:
Issue Date: July.02, 2001
Model: M170E2-02
Approval
Unit Note
Relative Humidity (%RH)
Relative Humidity (%RH)
100
100
90
90
80
80
60
60
Operating Range
Operating Range
40
40
Storage Range
Storage Range
0
20
40
-40
-20
20
20
5
5
Temperature (ºC)
Temperature (ºC)
ELECTRICAL ABSOLUTE RATINGS
(1) TFT LCD MODULE
6/24
Valu es
Unit Note
Item Symbol
Power Supply Voltage Vcc -0.3 6.0 V
Input Signal Voltage VIN -0.3 4.3 V
Min. Max.
60
8060-20 400 20-40
Ta = 25 ± 2 ºC
80
Version 3.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
R
GBR
G
R
G
R
GBR
G
R
G
R
GBR
G
R
G
R
GBR
G
R
G
R
GBR
G
R
G
R
GBR
G
R
G
(2) BACKLIGHT UNIT
Item Symbol
Lamp Current IL 6.0 13.0 14.0 mA
Lamp Frequency FL 30 45 80 KHz (1)
Note (1) Permanent damage to device may occur if maximum values are exceeded. Function operation
should be restricted to the conditions described under Normal Operating Conditions.
Note (2) Specified values are for a dual lamp (Refer to the Note (1) of 2.2 BACKLIGHT UNIT for further
information).
2. ELECTRICAL SPECIFICATIONS
2.1 TFT LCD MODULE
Parameter Symbol
Power Supply Voltage VCC 4.5 5.0 5.5 V Power Supply Current l
Ripple Voltage Vrp - - 100 mV LVDS differential input voltage Vid 100 - 600 mV
LVDS common input voltage Vic - 1.2 - V
Logic “H” input voltage (TEST pin) Vih 2.0 - 3.6 V Logic “L” input voltage (TEST pin) Vil Vss - 0.8 V Rush Current Irush - - 1.55 A (2)
Note (1) Measured with 2 lines vertical stripe pattern.
B
B
www.panelook.com
Dcc No.:
Issue Date: July.02, 2001
Model: M170E2-02
Approval
Value
Min. Typ. Max.
MODULE
Valu e
Min. Typ. Max.
- - 1850 mA (1)
CC
LCD Panel
B
B
B
B
B
B
Unit Note
(1),(2)
RMS
Unit Note
B
B
B
B
Slash area is lighted off. The other white area is lighted on.
7/24
Version 3.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
Note (2) Measurement Conditions
www.panelook.com
Dcc No.:
Issue Date: July.02, 2001
Model: M170E2-02
Approval
(High to Low)
(Control S ignal)
SW
+12V
C1
1uF
GND
+5.0V
R1
47K
VR147K
0.1VCC
Q1 2SK1475
FUSE
R2
1K
Q2
2SK1470
C2
0.01uF
C3
(LCD Modul e Input)
1uF
VCC
+5.0V
0.9VCC
470us
2.2 BACKLIGHT UNIT
BACKLIGHT ( 2 Dual CCFLs)
Parameter Symbol
Min. Typ. Max.
Lamp Input Voltage VL 640 720 800 V
Lamp Current IL 6.0 13.0 14.0 mA
Lamp Turn On Voltage VS
- - 1150 V
- - 1500 V
Operating Frequency FL 30 45 80 KHz (1)
Lamp Life Time LBL 50,000 - - Hrs 13mA
Power Consumption PL - 9360 - mW (4)
Note (1) Lamp current is measured by utilizing a current meter for high frequency as shown below:
LCD
Module
Hot 1 (Pink)
Hot 2 (Pink)
GND (White)
1
2
4
8/24
Value
A
Current meter
Inverter
Unit Note
(1)
RMS
(1)
RMS
25oC
RMS
0 oC
RMS
Version 3.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Loading...
+ 18 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.