CMD Chip Instruction Manual

Chip - Information and Instruction Guide

Part No: 133800

Main features

1. Available in a choice of black,
grey or white with matching
surround (other combinations
are available subject to MOQ and
lead times).

2. Fully integrated 4A USB PCB
providing max 2 Amp power
supply at each port.

3. Designed to connect to your
existing desk power systems.

4. Independently tested to
IEC 60950-1 - Information
technology equipment – Safety.

Chip is a new 4A USB charging module set to revolutionise the way we use on desk
power. With more and more devices using USB the demand for traditional sockets
on the desk is falling. This stylish and fully integrated module simply connects to
your under desk power using a Wieland or plug to offer 2 USB power supplies
capable of charging all leading phones and tablets.

Chip - Information and Instruction Guide

Part No: 133800

C clamp Fixing Instructions

1. The Chip module is supplied with
the C clamp installed (g. 01).

2. Place the unit in the desired
position on the desk surface and
ensure the C clamp is tight up
against the edge of the surface
(g. 02).

3. Tighten the C clamp bolt with
a 5mm Allen key (not supplied).
Do not use power tools (g. 03).

4. The C clamp has been designed
to t desk thicknesses between
15mm and 35mm.

5. Once the module is connected to
the power supply your device can
be charged using any standard
USB cable (g. 04).

g. 01

g. 02

g. 03

g. 04