CM Promarks Promax TMC-150, Promarks Promax TMC-300, Promarks Promax TMC-500 Operation Manual

TMC-150/300/500

Vacuum Tumbling Machine

Operation Manual

Version 6.9.1

PROMARKS INC

1915 E. Acacia Street, Ontario, CA91761, U.S.A

TEL : [phone]
FAX : [phone]

http://www.promarksvac.com

S/N: QC SIGNATURE:

TABLE OF CONTENTS

1. INSTALLATION …………………………………………………………………... 1

2. MAINTENANCE ………………………………………. …………………………. 1

3. FUNCTIONS OPERATION…….. ………………………………………….. …... 1

4. MACHINE SPECIFICATION……………..……………………………………….2

5. MACHINE OPERATION EXPLAIN…. ……………..…………………………...3

6. FABRICATION ……………………………….………………………………… ..4

6.1 DRUM BODY………………………………………………………….…… 5-6

6.2 MACHINE CASE…………... ………………………………………..……..7-10

6.3 ELECTRICAL BOX ……………………………………………………..11-12

1. INSTALLATION

Please check the electric power listed on the vacuum pump and install the vacuum

pump correctly,

ground line must on the floor.

2. MAINTENANCE

A. To ensure vacuum pump works smoothly suggest change the vacuum oil every

500 working hours or every a half year.



B. Check water filter bottle everyday, as soon as the water over a half of the bottle

please cleans it.

3. FUNCTIONS AND OPERATIONS

1 Mix time
2 Barrel speed
3 Vacuum
4 Vacuum pump ON/OFF switch
5 Tumble ON/OFF switch
6 Inch moving tumble forward/Reverse

Cleaning. The tumbler inside must be cleaned everyday after working hours.

3

1

2

4

5

1

6

4. MACHINE SPECIFICATION

2

3

5.MACHINE OPERATION EXPLAIN.

Check the right power source with the name plate of the machine. Plug in the power and
ready to operate the machine.

Turn on main power switch and set the value on control panel. After finish all of the
setting push down the safety bar and press “Start/Pause” button to start the function.
Safety function will be effective and machine will stop at the same time while user
pull up the safety bar or gear motor box during working process.

After vacuum tumbling job finish, machine will stop and air ventilation at the same time.
As soon as machine finish air ventilation, open the vacuum cover and use unloading
switch to unload the product in drum.

The stopper on the side of the machine is design to hold the drum and remain it in the
same angle and help user to load in the processing product. How to use the stopper:

A. Push in the handle bar of stopper to the hole of the drum before load in the

processing product.

B. Pull back the handle bar of stopper from the hole of the drum before start the

machine.

Warning: The handle bar of the stopper must be pulled back before user start the
machine!! The machine will be damaged if user have not fulfill it!!