CLR CLRMC4PRO, CLRMC-4PROEA User Manual

SAFETY DATA SHEET

CLR PRO METAL CLEANER

1 - PRODUCT AND COMPANY IDENTIFICATION

SDS ID: 98CP1012
Product Name

Product Use Aqueous Slightly Acidic Cleaner for Cleaning and Enhancing the Appearance of

CAS# Proprietary Mixture
Restrictions on Use: Incompatible with strong oxidizing agents, acids, bases, and bleach. Do not use on

Manufacturer: Jelmar, LLC Emergency Phone Number: 1(800) 323-5497 (USA)
Address: 5550 W. Touhy Ave. Monday – Friday 8:30 A.M. – 4:30 P.M. CST
Skokie, IL 60077 Emergency 24 hour Contact: Chemtrec 1(800) 424-9300

Emergency Overview: WARNING: MILD IRRITATANT. GHS Toxicity Category 2B Causes eye irritation

Potential Short Term Health Effects
Routes of Exposure Eyes, Skin, Inhalation, Ingestion.
Eyes Mild Irritant

Avoid eye contact

Effects may vary depending on length of exposure, solution concentration

Skin Mild Irritant. Prolonged contact may cause dermatitis, and itching.
Inhalation No adverse effects expected under typical use conditions.
Ingestion Oral burns, vomiting, and gastrointestinal disturbance.
Target organs Eyes. Skin.

CLR PRO METAL CLEANER

Metal and Stones. Industrial Sizes: 1, 5, and 55 gallons

appliance stainless steel that requires emulsion cleaner, marble, pearls, opals, and
other porous stones.

2 – HAZARDS IDENTIFICATION

and possible SKIN IRRITATION - GHS Category 3 on sensitive skin.DO NOT get
in eyes, on skin or clothing. DO NOT mix with bleach or other household
chemicals as harmful fumes may result. DO NOT ingest. DO NOT breathe vapor
or mist. Use in well ventilated areas. Keep container closed when not in use.

KEEP OUT OF REACH OF CHILDREN

SECTION 3 - COMPOSITION /INFORMATION ON INGREDIENTS

98CP1012 Page 1 of 6 Date issued 01-October-2013

SAFETY DATA SHEET

CLR PRO METAL CLEANER

Component

1. Sodium Lauriminodipropionate 14960-06-6 YES 1.00-4.00

EYE CONTACT: In case of eye contact, immediately rinse eye thoroughly with plenty of water. Remove
contact lenses, and continue rinsing for at least 15 minutes. If irritation persists, get medical attention.
SKIN CONTACT: Can be irritating to skin, prolonged contact can be more severe, no adverse effects
during normal usage. In case of skin contact, rinse area for at least 15 minutes. Remove contaminated
clothing and shoes, wash thoroughly before reuse. If irritation persists get medical attention.
INHALATION: Not a significant route of exposure. Remove to fresh air. If breathing is difficult, GET
MEDICAL ATTENTION IMMEDIATELY.
INGESTION: DO NOT induce vomiting. If fully conscious, drink 16 ounces of water. CALL A PHYSCIAN
OR POISON CONTROL CENTER IMMEDIATELY. NEVER give an unconscious person anything to ingest.

FLAMMABILTY: Not flammable
FLASH POINT: None; Method: ASTM D-56
EXPLOSIVE LIMITS IN AIR: Not available
EXTINGUISHING MEDIA: Not flammable. Use appropriate media for area. Use water spray, dry chemical,

alcohol foam or carbon dioxide.
FIRE FIGHTING METHODS: Evacuate area of personnel. Wear protective NIOSH-approved self­contained breathing apparatus. Remain upwind of fire to avoid hazardous vapors and decomposition
products. Use water spray to cool fire-exposed containers. Run-off of large quantities of product from fire
control may cause pollution. Contact appropriate agencies.
HAZARDOUS COMBUSTION PRODUCTS: Carbon Monoxide. Thermal decomposition can lead to
irritating gases and vapors.

FIRE AND EXPLOSION HAZARDS: None known.

Steps to be taken in Case Material is Released or Spilled: Avoid contact with skin and eyes
Small Spill: No special clean-up procedure is necessary for small (less than 1 gallon) spills. Flush spill

area with water. Wear rubber gloves.
Large Spill: Use personal protection recommended in Section 8. Isolate area, and deny entry to
unnecessary and unprotected personnel. Dam spill, and absorb with earth, sand or similar material. Place
in non-leaking containers. Dispose of collected material according to local, state, and federal regulations.
Flush residue with large amount of water. Avoid direct discharge to sewers and surface waters.

CAS# OSHA HAZARD % by Weight

SECTION 4 – FIRST AID MEASURES

SECTION 5 – FIRE FIGHTING MEASURES

SECTION 6 – ACCIDENTAL RELEASES MEASURES

SECTION 7- HANDLING AND STORAGE

98CP1012 Page 2 of 6 Date issued 01-October-2013

SAFETY DATA SHEET

CLR PRO METAL CLEANER

STORAGE: Store in cool, well-ventilated area, away from heat. Keep containers tightly closed. Avoid

contact with combustible materials, wood, and organic materials. Store in original container in a secure
area away from children and pets.
HANDLING: Avoid contact with eyes, skin or clothing. May be harmful or if swallowed. Use with adequate
ventilation. Avoid breathing vapors or mist. Do not eat, drink, or smoke in work area. Wash hand thoroughly
after use. Containers (1, 5, 55 gallons), should be rinsed and recycled. DO NOT PRESSURIZE, CUT OR
EXPOSE THESE CONTAINERS TO HEAT, FLAME, SPARKS, STATIC ELECTRICITY, OR OTHER
SOURCES OF IGNITION. THEY MAY EXPLODE AND CAUSE INJURY.

DO NOT MIX WITH BLEACH, OR ANY OTHER PRODUCTS AS TOXIC FUMES MAY RESULT. KEEP
OUT OF REACH OF CHILDREN.

SECTION 8 – EXPOSURE CONTROLS / PERSONAL PROTECTION

VENTILATION REQUIREMENT: Avoid prolonged breathing mists or dusts of this product. Use with

adequate ventilation. Do not use in closed or confined spaces.
RESPIRATORY PROTECTION: In industrial setting, respiratory protection must be worn if ventilation does
not eliminate symptoms or keep levels below recommended exposure limits. If mist or dust is present, wear
NIOSH-Approved respirator for dusts and mists, NIOSH-Approved self-contained breathing apparatus,
NIOSH-Approved full-face piece positive-pressure, air-supplied respirator. DO NOT exceed limits
established by respirator manufacturer.
Emergency responders should wear self-contained breathing apparatus (SCBA) to avoid inhalation of
product.
EYE PROTECTION: Industrial users wear safety goggles. Do not wear contact lenses. Emergency
responders should wear full eye and face protection.
SKIN PROTECTION: Rubber gloves with protective cuff. Emergency responders should wear
impermeable gloves.
OTHER PROTECTION: Emergency responders should wear chemical type (impermeable) protective
clothing and footwear where direct contact with chemicals in this product is possible.

WORK/HYGIENIC PRACTICES: Wash thoroughly with soap and water after use or handling.
EXPOSURE GUIDELINES:

COMPONENT

PEL STEL/C TWA STEL/C

1. Sodium Lauriminodipropionate N.E N.E. N.E. N.E.

Boiling point: 99ºC / 210º F Specific Gravity @20ºC: 1.000 – 1.020
Vapor Pressure: N.D. Percent Volatiles: ~93.9% (Calculated)
Freezing Point: N.D. Evaporation Rate: N.D. (nBuAc=1)
Melting Point: N.D. Total VOC (wt. %): 0% - does not include any
Vapor Density (mm Hg): N.D. (
pH: @20ºC ~5.5
Solubility in Water: 100%

STABILITY: Stable under normal conditions.
CONDITIONS TO AVOID: Avoid elevated temperatures.

OSHA ACGIH

ECTION 9 – PHYSICAL AND CHEMICAL PROPERTIES

Volatile Organic Compounds/ CARB applicable

California Air Resource Board) exemptions

SECTION 10 – STABILITY AND REACTIVITY

98CP1012 Page 3 of 6 Date issued 01-October-2013