CLP UNI 12 Operating Manual

KIT MONITOR LCD

UNI 12

MANUAL DE OPERAÇÃO

C E N T E R

Introduction

Features

Power Saver

This monitor is an open frame LCD Panel monitor. It features the VESA plug
& play system which allows the monitor to automatically adjust itself to the
match the frequency of the user's device. It now has wide viewing angle
capability. This allows for better image display when viewing from the sides,
top or bottom.

• Wide viewing angle.

• High brightness.

• Fast response time.

• Power saver.

• Low electromagnetic wave and power saver.

• Safety certifications.

• The power control system is installed inside the LCD monitor.

• If the monitor has not been used for a certain period of time, the system will
turn the monitor to low voltage mode to save power. Any button press will
return the monitor to original state.

• Your input device e.g. your computer controls the power saver mode. You can
adjust these settings via your computer

• The LCD monitor is compatible with EPA Energy Star and N Tek if used with
a VESA DPMS computer.

• To save power, turn off the power of the LCD monitor when it is not in use.

Plug and Play

• The VESA plug and play function eliminates the complicated and time­consuming installation process.

• As this is a plug and play monitor. Your computer system can easily

identify and automatically adjust the monitor.

• The LCD monitor uses Display Data Channel (DDC) to send Extended
Display Identification Data (EDID) to the computer system, so the computer
system can be set to monitor auto adjust.

C E N T E R

Setting up your
LCD monitor

Screen
Adjustment

• Choose a position where the reflection of the light is minimal and away from a
window for maximizing the quality of the screen image.

• It is important to keep 30cm between the LCD monitor to minimize eye strain.

• Position the LCD monitor slightly above your horizontal vision as you are
sitting.

• Tilt either forward or backward for the most comfortable angle to view the
monitor. This LCD monitor supports connection to a computer or a work
station.

To enter adjust mode, please refer to the OSD control.

• Turn the computer and LCD monitor on.

• Press “Auto” button to start auto adjust.

• This will start the auto adjust process. This will take approximately 10
seconds. You may notice the image changing and occasionally flashing (this is
normal).

• Your LCD monitor provides a self testing function, through which you can
check whether the LCD monitor functions are working properly.

• If your LCD monitor is properly connected, but there is no image showing and
the indicator lights up in orange, please follow the below steps:

• Shutdown the computer and the LCD monitor.

• Unplug the signal connector from the back of the computer.

• Turn the LCD monitor on.

• If the image connector is disconnected or damaged, a “No signal” sign will
pop up on the monitor.

• Turn off the LCD monitor and reconnect the signal cable, and then turn the
computer and LCD monitor on.

• If the LED of the LCD monitor is an orange colour after completing the steps
above, please check your VGA card and computer system. Your monitor
should be operating properly.

C E N T E R