INSTRUCTION
MANUAL
MINI COLOR DOME CAMERA
MODEL HDC365
Copyright © 2009 Clover Electronics U.S.A. All Rights Reserved.
PRECAUTIONS
• To prevent fire or shock hazard, do not expose the product to rain or moisture.
• To avoid electrical shock, do not open the case of this product.
• Operate this product using only the supplied AC Power supply.
• Do not overload electrical outlets or extension cords; this can result in fire or electric
shock.
• Keep this product away from strong magnetic fields.
• Do not expose this product in direct sunlight or strong reflected rays.
• Refer servicing to qualified personnel only.
• Do not change or modify this product, the warranty will be voided.
FEATURES
• 1/3” Sony Super HAD CCD
• High Resolution 540 TV Lines
• Rugged Steel Construction
• 4mm Fixed Board Lens
• Attached Mounting Bracket and 100’ cable
• DC 12V Power Source
INSTALLATION
1. Attach the mounting base① to the wall or ceiling, wherever you want to install the
camera. Locate a wall stud or ceiling joist and secure the mounting base using the
supplied screws②.
2. Set the desired angle of camera toward objects by pushing and moving the camera
body③ right /left and up/down.
3. Attach the camera body③ to the mounting base① and secure them with the supplied
screws④.
4. Put the transparent dome⑤ on to the camera body③ and then turn the locking ring⑥
clockwise to secure.
5. Connect the one end of 100’ cable (supplied) to the BNC (F) of 5’ cable attached to
the camera and the other end (BNC) of cable to the video devices such as DVR,
monitor/TV. Plug the provided AC power supply to the DC jack (red) on the end of
100’ cable.
g
Note:
▪ Apply the provided AC power supply only.
▪ The total length of cable must not exceed 300’ includin
extension
cable.
TROUBLE SHOOTING
If the camera does not function properly, check the following points before contacting the
service center.
Troubles Remedies
No video Check the AC adapter and video cable
between the camera and a monitor
The image on the screen is dark Check the brightness control on the
monitor
The image on the screen is dim Check if the lens is stained. If dirty,
clean it with soft and clean cloth
The camera is not working properly, and
the surface of the camera case is hot
The contrast on the screen is too weak Adjust the contrast feature of the
The image on the screen flickers Does the camera face to directly to the
Picture rolls and jumps, scrambled
picture
Picture smaller than screen House current may be too low
Check if you have connected the
provided AC adapter
monitor. If the camera is exposed under
too strong light, change the position
sunlight or fluorescent light? Change the
camera position
Improper V-hold control. Setting on your
monitor
SPECIFICATIONS
• Image sensor 1/3” SONY Super HAD CCD
• Effective Pixels 768(H) x 494(V)
• Scanning system 2:1 Interlace
• Sync system Internal
• Resolution 540TV Lines
• S/N Ratio More than 46dB
• Min.illumination 0.1Lux
• Gamma characteristic r=0.45
• Video output CVBS:1.0Vp-p 75 ohm
• Electronic shutter speed 1/60sec to 1/100,000sec
• Voltage DC12V
• Current consumption 80 mA
• Lens
• Operating temperature/Humidity -10°C ~ +50°C. RH 95% Max.
• Storage temperature/Humidity -20°C ~ +60°C. RH 95% Max.
• Dimensions 88 (Ф) x 59(H)mm
• Weight 1.3 Lbs
4mm fixed board lens
LIMITED 2 YEAR WARRANTY
This warranty gives the original purchaser specific legal rights and you may also have
other rights, which vary from state to state. If our products do not function because of any
defect in material or workmanship, we will repair free of charges for 2 years on parts and
labor from the date of original purchase. This warranty does not cover modification,
abuse, incidental or consequential damages unless the state of owner’s residence specially
prohibits limitations on incidental or consequential damages.
HOW TO OBTAIN FACTORY SERVICE
1. Original purchaser must fill out a warranty card and mail it to the factory with model
number, serial number and the date of purchase.
2. We will repair or replace, and return to the owner the system under this limited
warranty.
3. Please pack the system carefully and securely using the original packing materials,
and send it prepaid and insured to: 13073 E. 166
4. Please include a check for $15.00 to cover the cost of return postage and handling. If
the system is returned within the warranty period, please include a proof of purchase.
If the system is out of warranty, you will receive an estimate of the repair cost for
your approval before repair work will be begun.
AVAILABLE ACCESSORIES
CDR0460 Stand-alone 4 CH Digital Video Recorder (DVR)
CDR4450 Stand-alone 4 CH Digital Video Recorder (DVR)
CDR0860 Stand-alone 8 CH Digital Video Recorder (DVR)
CDR1660 Stand-alone 16 CH Digital Video Recorder (DVR)
CDR0850 Stand-alone 8 CH Digital Video Recorder (DVR)
CDR1650 Stand-alone 16 CH Digital Video Recorder (DVR)
CA100BP 100’ BNC/Power to BNC/Power Extension cable and coupler
PACKAGE INCLUDES
1-Mini Color Dome Camera
1-Mounting Bracket & 100’ BNC/Power to BNC/Power cable
1-UL Approved AC Power Supply
1-Hardware Accessories Kit
1-Instruction Manual
1-Warranty Registration Card
th
St, Cerritos, CA 90703.
Loading...