Clover TFT1904Q Setup Manual

INFRA-RED RECEIVER MODE/← VOLUME ▼/↓ TALK

MICROPHONE MENU CH/→ VOLUME ▲/↑ POWER

1.

® : Receives signal from remote controller to the monitor.

2. MENU Button : After pressing this button, user can go into the “SETUP” Menu. To select any of Menu items, press the

button again. This button is also used by down arrow key in Sub-Menu.

3. MODE/← Button : Press this button to display the Quad, Live, PIP and the POP modes. This is also used by Left arrow key

in Sub-Menu.

4. CH/→ Button : It displays each 1CH, 2CH, 3CH and 4CH in full screen when this button is pressed. For Example,

1CH→2CH→3CH→4CH→1CH. When user wants to talk to a specific camera location, choose one of channels. This is

also used by Right arrow key in Sub-Menu.

5. ▼/↓ Button : Decreases volume sound. This button is used by down arrow key in Setup Menu. And this is also used by

changing the value in Sub-Menu.

6. ▲/↑ Button : Increases volume sound. This button is used by up arrow key in Setup Menu. And this is also used by

changing the value in Sub-Menu.

7. TALK Button : The two-way audio feature. By pressing and holding this button the user has the ability to talk to a specific

camera location. This button must be pressed the entire time while talking. To listen to the camera location releases the talk

button.

8. Φ Button : Power on/off.

Configuration of the Rear Panel

CAMERA 2 CAMERA 4 MONITOR OUT AUDIO IN DC IN

CAMERA 1 CAMERA 3 VCR IN VCR OUT AUDIO OUT

1. CAMERA INPUT 1~4 : Channel 1~4 camera Inputs (6 Pins Din Connectors)

2. VCR IN : To receive video signal from an external source(VCR or DVR)

3. MONITOR OUT: To transmit video signal from the Monitor to a Slave monitor.

4. VCR OUT: To transmit video signal from the Monitor to a VCR or DVR

5. AUDIO IN: To receive audio signal from an external source

6. AUDIO OUT: To transmit audio signal from the Monitor to an external source

7. DC IN : Power source for the monitor.

Installation

Connect the supplied breakout cables to 4 camera inputs (6 pin Din) on the rear panel of the monitor and then connect cameras.

Connect external sources and/or a VCR

Connect a slave monitor or VCR to the Video IN located on the rear panel of the Monitor.

Connect a power supply (DC12V)

Plug the supplied power supply to DC IN jack located on the rear panel of the Monitor.