Clover TBUN15070, TBUN19070, TFT1504Q, TFT1904Q Quick Installation Manual
Wall
Outlet
VIDEO IN
LOOP OUT V - OUT2
V - OUT1 A - IN
A - OUT
CH1 CH2 CH3 CH4
ETHERNET
POWER
AC INPUT
AC100-240V, 50/60Hz
MODEL NO : DVR4170
AC100-240V, 50/60Hz,25W
CLOVER ELECTRONICS
13073 EAST 166TH STREET, CERRITOS CA 90703
Factory ID/DHHS CODE : BC
ALARM IN ALARM OUT
GND
RS485
+ -
®
US LITED
E233232
AUDIO VIDEO EQUIPMENT 2UW2
ATTENTION
NE PAS ENLEVER
RISQUE DE CHOC ELECTROIQUE
DO NOT OPEN
RISK OF ELECTRONIC SHOCK
CAUTION
Rear view of DVR
Quick In stal lat ion For
TBUN15070 / TBUN19070
1.Attach the mounting bracket to the desired location on the wall or
ceiling, wherever you want to install the camera. Locate a wall
stud or ceiling joist and secure the mounting bracket using the
supplied screws.
2.Attach the camera to the mounting bracket and firmly tighten the
swivel.
3.Connect the one end of 60’ cable ① to the Din jack on the rear of
the camera and the other end of cable to the 2’ cable�. Make
sure that two arrows on the top of them should be aimed at each
other.
4.Connect the BNC (yellow) of the end of 2’ ②to one of camera
inputs on the rear of DVR and DC jack (red) to an AC adapter
(ADT120250).
5.Connect the one end of 3’ BNC to RCA cable③to the VIDEO OUT
on the rear of DVR (CDR4170) and the other end (RCA Plug) to
VCR IN on the rear of TFT monitor (TFT1504Q/TFT1904Q).
6.Plug the DC plug ④ of AC adapter for TFT monitor (DC12V 5A) to
DC IN jack on the rear of monitor and to AC outlet.
7.Turn on the power switch on the front panel of the TFT monitor.
8.Press the VCR button on the provided Remote Controller.
9.How to operate the DVR: refer to user’s manual.
CDR4170
REAR VIEW
MONITOR (TFT1504Q/TFT1904Q)
Camera
1
60
2
2
Yellow
Red
Black
3
4
REAR VIEW
MONITOT OUT
VCR IN VCR OUT AUDIO OUT
AUDIO IN
DC IN
Wall
Outlet
Power
Adapter
r
et
padA
Loading...