Closet Maid 6601 User Manual
1
75381 06601
03
Mark wall for wall clip locations. Locate a wall clip 2” from
each end of shelf and in equal increments (no more than12”)
between the two wall clips on each end.
Marque la pared para las ubicaciones de los clips. Ubique un
clip a 5,1cm de distancia de cada extremo de la repisa en incrementos iguales (no más de 30,5 cm) entre dos clips
de extremo.
2
Drill 1/4” holes through wall. DO NOT PUNCH HOLES. Push each
anchor into drilled hole. Use bottom of hammer handle to push in
pin. For removal, pry pin out with screwdriver.
Perfore agujeros de 6 mm a través de la pared. NO LOS PUNZONE.
Empuje cada anclaje precargado en el agujero perforado. Use la
parte inferior del mango del martillo para empujar el pasador hacia
adentro. Para remover, palanquee el pasador para sacarlo con un
destornillador.
6601
satisfaction when installed in
dance wit
accor
it will be exchanged free of charge. Only the unsatis-
factory part in a multi-piece product
hanged.
c
x
will be e
Consumer Toll-Free Help Line
1-800-874-0008
(U.S.A
Manufacturer reserves the right to
change specifications without notice.
Made inUSA
©
Ocala, FL 34478-4400
Canada)
and
ClosetMaid Corporation 2005
h manuf
actur
er's ins
uctions,
tr
e
t
ple
e user com
t giv
oduct does no
tMaid® pr
If a Close
01-84620
Loading...