Clippasafe 120 Pressure Fit Gate User Manual

Pressure Fit
Gate (Metal)

WIDTH

Adjustable from 71 to 80,5 cm

HEIGHT

Top of gate to oor 78 cm

A

x 4

B

x 3

C

x 2

D

x 4

E

x 1

WARNING - INCORRECT FITTING
OR POSITIONING OF THIS SAFETY
BARRIER CAN BE DANGEROUS

Fixing surfaces must be suitable
for the purpose and structurally
sound.

This product requires the purchase

for the surface to which the wall

a round shaped newel post,
‘Y’ shaped spindles are available
separately which replace the screw
adjusters and wall cups supplied
with this gate.

Pre-Installation Advice

WARNING - NEVER USE WITHOUT WALL CUPS

WARNING - GATE MUST BE FITTED UPRIGHT

AS SHOWN

WARNING - THE GATE SHOULD BE POSITIONED
SO THAT IT OPENS AWAY FROM THE STAIRS

Installation

1

On the latch side of the gate, insert 1 screw adjuster ‘A’ with nut ‘B’ into
the holes provided on the bottom of the gate. Screw 1 screw adjuster ‘A’
into the hole provided next to the handle. On the other side of the gate
insert 2 casings ‘C’ followed by 2 screw adjusters ‘A’ with nuts ‘B’ into the
holes provided. Be sure to insert both casings ‘C’ with the notch
facing downwards.

C

B

A

A

B

A

Mark the position for the wall fixings ‘D’ on the wall surface you wish the

2

C

B

A

gate to hinge from. The hole for the lower wall fixing should be 26.5mm
from the floor. The hole for the upper wall fixing should be 721.5mm from
the floor. On the other side of the opening mark the position for the wall
fixings ‘D’. This should be the side you want the gate to open from. The
hole for the lower wall fixing should be 26.5mm from the floor. The hole
for the upper wall fixing should be 724mm from the floor.

721.5mm

26.5mm

D

4

724mm

26.5mm

Fix the wall fixings ‘D’ using the appropriate
fixings depending on the surface available:
wood screws for wooden surfaces, multi-use
dowel and concrete screws for concrete
surfaces, multi-use dowel and cement screws
for cement surfaces, metal screws for metal
surfaces. These screws are not provided.