Clippasafe 112 Extendable No Trip Gate User Manual
Adjustable from 61 to 109 cm
WIDTH
HEIGHT
Top of gate to floor 75 cm
Extendable
No-Trip Gate
IMPORTANT - READ AND FOLLOW
THESE INSTRUCTIONS CAREFULLY
AND KEEP FOR FUTURE REFERENCE
This safety barrier conforms to EN 1930:2011 when fitted according to these instructions between
two clean, structurally sound surfaces.
This safety barrier is designed for children up to 24 months.
This safety barrier is for domestic use only.
Manual closure system.
Suitable for fixing across door openings and at the top and bottom of stairways.
Make sure that you use the appropriate type of fixings depending on the surface available;
wood screws for wooden surfaces, multiple usage dowels and concrete screws for concrete surfaces,
multiple usage dowels and cement screws for cement surfaces and metal screws for metal surfaces.
If the gate has been exposed to an accident, it must not be used again.
Do not allow older children to climb over this gate as this may pose a danger.
WARNING: Read these instructions before installation as incorrect installation can be dangerous.
WARNING: Incorrect fitting or positioning of this safety barrier can be dangerous.
WARNING: The safety barrier must not be fitted across windows.
WARNING: Stop using the barrier if the child is capable of climbing over it.
SCREWS x4 SCREWS x4
21
WALL CUP x1
6
WALL CATCH x1 HINGES x2
7 8
SPINDLE x2 HINGE BARS x2
3
NUTS x2
4
5
9
GATE
SPANNER x1HINGE COVERS x2
WARNING - INCORRECT FITTING OR
POSITIONING OF THIS SAFETY BARRIER
CAN BE DANGEROUS
The gate must be fitted in a structurally
solid opening, free of dirt and grease.
The position of the safety barrier in relation
to the stairs may have an adverse affect on
your child’s safety:
- If the barrier is used at the top of the
stairs to prevent your child from falling
down the stairs, it must not be placed on
any stair below the level of the top stair.
- If the safety barrier is used at the
bottom of the stairs to prevent your
child from climbing up the stairs, it must
be placed on the lowest stair.
This product requires the purchase
of appropriate fixing aids suitable
for the surface to which the hinges
and catches are to be fitted.
LOW PRESSURE MOUNTING
WITH SCREW FIXED HINGES
AND WALL CATCHES
This gate is suitable for openings
between 61cm (24in) and 109cm (43in)
wide.
1. Measure the with of the opening
where you wish to place the gate in.
2. Adjust the two gate sections to one
of the eight lettered positions A-G,
according to the size of the opening.
3. Align the holes on both gate sections.
Secure the gate sections together by
fastening 2 x screws (1) into 2 x
screws (2) on the top bar of the gate
and 2 x screws (1) into 2 x screws (2)
on the bottom bar of the gate.
A
1 2 3 4 5 6
+
+
X = 61 68 cm
X = 68 74 cm
F
X = 74 81 cm
X = 81 89 cm
X = 89 95 cm
X = 95 102 cm
X = 102 109 cm
2
1
X
E
C
B
D
A
+
A
+
A
+
B
+
C
+
D
+
E
2
1
6
3
D
+
6
2
E
+
6
1
F
+
1
5
F
+
1
4
F
+
1
3
F
+
1
2
F
Loading...