Clinton CLASSIC Series, 1030, 1010, 1020, 1013 Assembly Instructions Manual

CLASSIC SERIES
TREATMENT TABLES

MODELS 1010, 1020 1030 & 1013

with ADJUSTABLE BACKREST

or NON-ADJUSTABLE TOP

ASSEMBLY INSTRUCTIONS

ASSEMBLY INSTRUCTIONS FOR CLASSIC SERIES TREATMENT TABLES

MODELS 1010, 1020, 1030 & 1013 with ADJUSTABLE BACKREST/KD & Tables with pre-attached backrest

For MODELS 1010, 1020, 1030 & 1013 with NON-ADJUSTABLE TOP & PRE-ATTACHED TOPS begin assembly with STEP 4

MAXIMUM WEIGHT CAPACITY 400 LBS

Thank you for counting on Clinton to meet your medical

equipment needs by purchasing this fine equipment. All

Clinton equipment is designed and manufactured to pro-

vide years of dependable service because we want you as a

customer now and in the future. Below are easy to follow

instructions on how to properly assemble your equipment.

Please contact us at 800-441-9131 if you experience any

difficulty with the assembly or have questions.

INTENDED USE

Clinton treatment table, models 1010, 1020, 1030 & 1013,

are specifically designed and engineered for the use by a

single person at a time, who is attended to and observed

by trained medical personnel. Never leave anyone on the

table unattended. Person’s weight and the combination

of force exerted on the table during treatment is not to

exceed a total of 400 lbs.

KD

Quantity

(4) 11/2" Truss Head Screws (4)

(8) 1" Truss Head Screws (0)

(8) 5/16" Washers (4)

(4) 5/16" Nuts (4)

(2) 21/4" Pan Head Screws (2)

(2) 3/4" Barrel Bolts (2)

(4) 11/4 "

Tools Required

Phillips Screwdriver and Adjustable Wrench

Hardware Package

Truss Head Screws

(1030 & 1013) (4)

Pre-Attached

Quantity

IF TOP IS ATTACHED TO FRAME, SKIP TO STEP 4

Align the holes in the hinge with the holes in

2

FOR MODELS WITH ADJUSTABLE BACKREST

3

finish tightening screws.

FOR MODELS WITH ADJUSTABLE BACKREST

the center board and fasten to center board

using 4 silver, 1" truss head screws.

Finger tighten the top's foot end to frame using

4 silver, 1" truss head screws and 5/16" washers.

Slide the foot end toward the center board and

Place the upholstered sections on a flat surface

1

the head end on right with hinge toward the center of the

table. Place frame on top with channel, teeth down, above

the head end.

FOR MODELS WITH ADJUSTABLE BACKREST

with the foot end on the left and fabric tag

toward the center of the table as shown. Place

fabric tag teethcenter hinge