Climax Technology Co WSL Users manual

WWSSLL WWaatteerr SSeennssoorr

The Water Sensor is designed to detect if the water level is above a certain level that may damage your
protected goods. When water level is above your installed level, the Water Se nsor will send signal to URL f or it
to react accordingly.

1. LED

2. Buzzer

3. Battery

4. Function Switch Block

5. Antenna

6. Probe

7. Protective Cover

z

z

FFuunnccttiioonn SSwwiittcchh BBlloocckk

Sliding down the protective cover carefully; you can see a switch block set which consists of 8 switches
marked as 1 ~ 8 from left to right. When the switch is in up position, it indicates the “+ mode. When the
switch is in middle position, it indicates the “0” mode. When it is situated in down po sition, it indicates the
“-” mode. Slide all 8 switches to make them identical to your URL switch setting. This will connect the
WSL to URL and allow URL to received signal from WSL.

z

z

PPOOWWEERR SSUUPPPPLLYY::

z

The Water Sensor uses a 12V alkaline battery as its power source.

z

z

z

IINNSSTTAALLLLAATTIIOONN::

The Water Sensor can be installed in 2 ways:
a) Place on an even surface to stand on 2 sponge feet.
b) Mount on wall surface according to the height of water detection level you desire.
Step1: Clean the surface with a suitable degreaser.
Step2: With the provided VELCRO soft tape and hard tape held together, remove the protective cover
from the soft tape and firmly apply to back of device,

Step 3: Next remove the protective covering from the hard tape and firmly press the device onto the
desired location.

>

<<NNOOTTEE>

" Do not mount on a surface with peeling or cracked paint, or on a rough surface.

z

z

NNOORRMMAALL OOPPEERRAATTIIOONN::

z

When the Probes come in contact with water, the LED will light up and the Buzzer will buzz. The

z

Water Sensor will transmit signal to URL for the URL to react accordingly.

1

z

z

z

z

After the water ebbs and the Probes are no longer in contact with water, the LED will turn off and

the buzzing will stop.

>

<<NNOOTTEE>

FCC&IC Caution:

This device complies with Part 15 of the FCC Rules and Canada licence-exempt RSS-210
standard. Operation is subject to the following two conditions:

OPERATIONS IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE

(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING

INTERFEERENCE THAT MAY UNDESIRED OPERATION.

" After the water ebbs and the probes are no longer in contact with water, please

ensure that the Probes are wiped dry.

2