Climax Technology Co RPN Users manual

26-APR.-2005

INSTALLATION GUIDE

z SYSTEM CONFIGURATION

Locator (LT-49): It is used for receiving 433 MZH device signal and transmit it in 912

MHZ to Repeater (RPN-99) or Base Unit (BUN-152).

Repeater (RPN-99): It is used to relay whatever signal received with same Group number

and System ID in 912 MHZ.

Base Unit (BUN-152): To receive the signals from LT-49 and RPN-99 in 912 MHZ.

z SYSTEM CAPIBILITY:

z Each system can have maximum of 4096 LT-49 and 4096 RPN-99.
z Each Locator and Repeater has its own ID Code set by a 12-pin Dip Switch.
z The frequency hopping technology is adopted in the communication between

Locator, Repeater and BUN-152.

z There are three groups of hopping frequency bands are available. Each group

contains 25 channels:

GROUP 1: 906.26 ~ 914.90 MHZ, 25 channels
GROUP 2: 906.38 ~ 915.02 MHZ, 25 channels
GROUP 3: 906.50 ~ 915.14 MHZ, 25 channels

1

BUN-152

z Front View of BUN-152:

LED:

— When the Power is ON, the LED will stays on. It flashes moment when either

RPN-99 or LT-49’s signal has been received.

ANTENNA connector (TNC connector):

— It has two connectors for Antenna. During the installation, be sure to put both

Antennas upwards and then screw it towards the TNC connector.

z Rear View:

DC JACK: For connecting to 12V 500mA Power Adaptor
RS-232 CONNECTOR: Connects the RS-232 cable to PC.

1
6
2
7
3
8
4
9
5

Pin2: TXD
Pin3: RXD

DC JACKRS-232

TXD
RXD

GND

Pin5: GOUND
Pin 1,4,5,6,7,8,9 : No Connection.

2

z Interior View:

SW1: It is used for setting the number of Groups. There are 3 Groups for use with

its own frequency band.

SW1: The SW1 switch block contains 3 dip switches. Slide the SW1 up (On

position) with SW2 & SW3 down (Off position), to select Group1 frequency
band. Likewise, slide SW2 or SW3 up (On) with others, down (Off), Group2
or Group3 is selected accordingly.

SW1 SW2 SW3 Group

On Off Off Group1
Off On Off Group2
Off Off On Group3

GROUP 1 frequency: 906.26 ~ 914.90 MHZ, 25 channels with spacing of

360KHZ between each channel.

GROUP 2 frequency: 906.38 ~ 915.02 MHZ, with spacing of 360KHZ

between each channel.

GROUP 3 frequency: 906.50 ~ 915.14 MHZ, with spacing of 360KHZ

between each channel.

SW2: For setting the system ID code, there are total of 16 SYSTEM ID

combinations for use from 0 to 15.

3

<<EEXXAAMMPPLLEE>>

System ID = 3

<<NNOOTTEE>>

)

Remember to set BUN-152’s “Group” and “System ID” identical with
RPN-99 and LT-49’s setting in order for them to communicate between
each other.

4