Climate King HCK-TP30, HCK-TP15 User's Manual And Operating Instructions

1

Model: HCK-TP15; HCK-TP30

1.1 This appliance can be used by children aged from 8 years and above and

persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children should not play with the appliance. Cleaning and user
maintenance should not be undertaken by children without supervision.

1.2 WARNING: In order to avoid overheating, do not cover the heater.

1.3 Children under 3 years old should be kept away from the appliance unless

continuously supervised.

1.4 Children aged from 3 years and less than 8 years should only switch the
appliance on/off provided that it has been placed or installed in its intended normal
operating position and they are supervised or given instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children aged
from 3 years and less than 8 years should not plug in, adjust and clean the
appliance or perform user maintenance.

1.5 CAUTION-some parts of this product can become very hot and have the
potential to cause burns if touched. Particular care must be given where children
and vulnerable people are present.

1.6 Disconnect the heater from the mains power supply before servicing or
performing any cleaning. Servicing and maintenance must only be undertaken by
a qualified electrician or service agent.

Climate

King®

User Manual and

Operating

Instructions

INDUSTRIAL

FAN

HEATERS

READ INSTRUCTIONS CAREFULLY: Read and follow all

instructions. Keep these instructions in a safe place for future reference. Do
not allow anyone who has not read these instructions to assemble, adjust or
operate the heater.

This product is only suitable for well insulated spaces or occasional
use.

2

2. Introduction

2.1 Depending on the power cord fitted this fan heater may be used in certain

locations such as households, warehouses and workshops, building sites or
greenhouses. It incorporates a thermostat and a self-resetting thermal cut-out to
control the heating elements. The thermostat detects the air temperature and
controls the heat output of the appliance. The fan motor is not controlled by this
thermostat and it continues working when the thermostat switches off the heating
element. The self-resetting thermal cut-out will switch off the heater to prevent
overheating. There is an additional thermostat to control the fan motor. If the
temperature inside heater is high, and the heater is connected to the power supply,
the thermostat may cause the fan to continue to run independently of the heat
selector dial setting. For example, after heating operation, when the heater is
turned off, the fan motor will continue to operate to reduce the temperature inside
the unit.

2.2 When using the heater for the first time, you may notice a slight emission of
smoke. This is quite normal and it will stop after a short time. The heating element
is made of stainless steel which was coated with a protective oil during
manufacturing. The smoke is caused by the residual protective oil when the heater
is switched on for the first time.

3. Technical specifications

Model

HCK-TP15

HCK-TP30

Voltage

380-400V

380-400V

Required power

15000W

30000W

Current

21.7-22.8A

43.3-45.6A

Setting

110/5000/10000/15000W

70/15000/30000W

Self-resetting Thermostat

65°C

80°C

Product Dimensions (mm)

495X520X860

645X565X860

Net Weight (kg)

21.7

31.2

3.1 Housing made of heat-resistant powder coated steel plate.

3.2 Supplied with industrial socket installed in the heater. A 3-Phase cable (not

included) of the correct rating fitted with a suitable connector is required to connect
the HCK-TP15 and HCK-TP30 to the power supply.

3

3.3 Coupler/3-Phase cable requirements:

Figure 1

1. Five pin connector 380V/415V 50/60Hz

2. Power cord

3. Five pin plug 380V/415V 50/60Hz IPX4

3.3.1. Any separately purchased coupler/cable should match with the appliance

and earthing pin layout. The coupler/cable should be approved for use in the local
country. The length of the power cord can be more than 1.8m but less than 3m. If
the power cord is too long and heavy, it could cause the cable to work loose from
the socket in the unit or cause a trip hazard. The specification for the cable and
socket for each model is shown below:

Model

Type of Power cord

Plug Current

Pin Layout

HCK-TP15

H07RN-F 4G2.5mm2

32A

3P+N+E

HCK-TP30

H07RN-F 4G6.0mm2

63A

3P+N+E

3.3.2 When connecting the power cable to the appliance, open the protective lid in
the direction shown below.

Figure2

3.3 After use shut down the appliance and remove the plug from the supply before

disconnecting the coupler end of the cable from the unit.

4

4. Description of Control Panel

HCK-TP15

Left Dial: Selector with heat setting
Right Dial: Thermostat dial

HCK-TP30

Left Dial: Thermostat dial
Right Dial: Selector with heat setting

5. Safety

5.1 Before use, review the marking on the power cord. Depending on the power

cord type this appliance may be used in different ambient conditions

Type

You can use the appliance in

Do not use in

H07RN-F

household, warehouses and
workshops, building sites or
greenhouses

H05RN-F

household, warehouses and
workshops or greenhouses

building sites

H05RR-F

household, warehouses and
workshops

building sites or greenhouses