CLF Lighting EF Smoke 1500 User Manual
manual
V1.0 APRIL 2018WWW.CLF-LIGHTING.COM
ef smoke 1500
WWW.CLF-LIGHTING.COM
2
Machine overview 3
Safety instruction 4
AC power 6
Data link 6
Physical installation 7
Operating instructions 7
Menu navigation 8
DMX channels 9
Maintenance 10
Specications 11
table of CONTENTS
WWW.CLF-LIGHTING.COM
3
machine overview
1. Fluid tube
2. Tank xing plate
3. 32 pcs LED
4. Ventilation
5. Power switch
6. Overload protection
7. PowerCON
8. 2,5L tank
9. Nozzle
10. 3-pin DMX socket
11. LCD display
12. Direct fog button
13. 5-pin DMX socket
14. Ventilation inlet
15. Handle
16. Safety point
WWW.CLF-LIGHTING.COM
4
Safety Instruction
The following symbols are used to identify important safety information on the product and in this manual:
WARNING!
Read the safety precautions in this section before
installing, powering, operating or servicing this
product
DANGER!
Safety hazard.
Risk of sev ere
injury or death.
DANGER!
Hazardous
voltage. Risk o f
lethal or severe
electric shock.
WARNING!
Fire hazard.
WARNING!
LED light
emission. Ri sk of
eye injury.
WARNING!
Burn hazard. H ot
surface. Do not
touch.
WARNING!
Wear protectiv e
eyewear.
WARNING!
Refer to user
m
anual.
Using for the rst time
This product is for professional use only. It is not for household use.
This product presents risks of severe injury or death due to re and burn hazards, electric shock and falls.
Read this manual before installing, powering or servicing the xture, follow the safety precautions listed below
and observe all warnings in this manual and printed on the xture. If you have questions about how to operate the
xture safely, please contact your supplier.
PROTECTION FROM ELECTRIC SHOCK
• Disconnect the machine from AC power before removing or installing any cover or part and when not in use
• Always ground (earth) the xture electrically.
• Use only a source of AC power that complies with local building and electrical codes and has both overload
and ground-fault (earth-fault) protection.
• Before using the machine check that all power distribution equipment and cables are in perfect condition
and rated for the current requirements of all connected devices.
• Power input and throughput cables must be rated 20 A minimum, have three conductors 1.5 mm² (16 AWG)
minimum conductor size and an outer cable diameter of 5 - 15 mm . Cables must be hard usage type (SJT
or equivalent) and heat-resistant to 90° C minimum.
• Use only PowerCON® cable connectors to connect to power input sockets. Use only PowerCON® cable
connectors to connect to power through put sockets.
• Isolate the machine from power immediately if the power plug or any seal, cover, cable, or other component
is damaged, defective, deformed, wet or showing signs of overheating. Do not reapply power until repairs
have been completed.
Do not expose the xture to rain or moisture
CLF EF Smoke 1500 has an IP20 rating, indoor use only.
Loading...