CLEVER BRIGHT CB BS091 User Manual

SAFTETY AND GENERAL INFORMATION:

Do not expose to water or attempt to speaker

disassemble speaker.

If exposed to water or disassembled, user may be at

risk of electric shock.

Handle this product with care; without proper care,

the device may not function properly.

Do not expose speaker to direct sunlight.

Device may get warm during charging.

Made in China

BLUETOOTH SPEAKER

CPP-4497

ON/OFF BUTTON

MICRO USB PORT

LED INDICATOR

(RED/BLUE)

FCC Statement

This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician
for help.

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.

Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.

CHARGING THE SPEAKER

The manufacturer recommends charging the battery

fully before using speaker for first time.

1. Connect the speaker to any 5V power source with

the USB cable provided.

2. LED turns ON during charging, turns OFF after Red

fully charged.

3. Unplug USB cable after fully charged; it takes about

1.5-2 hours to fully charge speaker.

PAIRING THE DEVICE

1. Turn on the Bluetooth function of your smart phone

or other Bluetooth device before pairing.

2. Press and hold the button on the bottom of the

speaker to enter into pairing mode

3. The blue light will flash when searching for Bluetooth

devices. Please select “CPP-4497” for pairing.

4. The Bluetooth speaker will finish pairing

automatically. The blue light will go from flashing

to solid once the device has connected successfully.

Note: After you pair the Bluetooth speaker to your

device for the first time, the speaker will connect to

your device automatically when you turn it on.

LED INDICATOR

Charging: LED ONRed

Fully Charged: Red LED OFF

Pairing Mode: LED flash quicklyBlue

Connected: LED onBlue

Playing: LED flash slowlyBlue