Clever Spa Paradiso Instructions Manual

INSTRUCTIONS

SS19 6 Person Square CleverSpa IM_AW.indd 1 30/10/2018 15:29

CONTENTS

Safety Instructions 02 - 03

CleverSpa® Parts Checklist 04

Indoor & Outdoor CleverSpa® Installation 05

Setting up your CleverSpa® 06 - 07

How to setup your Cleverspa® Ambient LED Lighting 08 - 09

Operating your CleverSpa® 10

Maintenance & Repair of your CleverSpa® 11

Cleaning & Storing away your CleverSpa® 12

Troubleshooting 13

Returns 14

Warranty 15

SAFETY INSTRUCTIONS - READ CAREFULLY!

When installing and using this electrical equipment, there are basic safety
precautions that should always be followed, including the following:

• The appliance should be supplied through a residual current device (RCD/GFCI type) with a rated
tripping current not exceeding 30mA.

• Electric installations should fulfil the requirements of local standards. Earthed appliances must be
permanently connected to fixed wiring.

• If the electrical supply cord is damaged, it must be replaced by the manufacturer, its service agent
or a similarly qualified person in order to avoid a hazard. Any damage to electrical cable should be
replaced by a competent party immediately before further use.

• To reduce the risk of electric shock, it is recommended not to use an extension cord to connect
the spa to the electrical supply, as there is a possibility that this could be defective.

• RISK OF ELECTRIC SHOCK. Never operate any external/additional electrical appliance when
in the CleverSpa
telephone, radio or television within 1.5m of the CleverSpa®.

• RISK OF ACCIDENTAL DROWNING. Extreme caution must be exercised to prevent unauthorised
access by children. To avoid accidents, ensure that children cannot use this CleverSpa® unless they
are supervised at all times.

• For health and safety reasons, we do not recommend any child under the age of 8 years use
our hot tubs. If a child older than 8 years is using the hot tub, then we recommend that the
temperature be set no higher than 37°C. At no time should any child be left unsupervised in the
hot tub, and when not in use, the cover should be fitted and locked, this will not only help to retain
the heat in the water but it will also ensure that no unsupervised child can access the hot tub.

• Water attracts children. Always lock the cover on the CleverSpa® after each use.

• The top cover is not a safety cover, and is not a substitute for responsible adult supervision;
children must be supervised around the CleverSpa® at all times.

®

®R

or when your body is wet. Never place any electric appliance, such as a light,

02

SS19 6 Person Square CleverSpa IM_AW.indd 2 30/10/2018 15:29

SAFETY INSTRUCTIONS

• It is recommended that you shower before using your CleverSpa®, as cosmetic products, lotions

and other residues on the skin can quickly degrade water quality.

• Do not switch on if there is any possibility that the water in the CleverSpa® or control system is

frozen.

• To avoid risk of accidental damage, pets should be kept away from your CleverSpa® at all times.

• During pregnancy, soaking in hot water may cause damage to the unborn foetus. We suggest that
you should limit use to 10 minutes each time. If you have any specific concerns please consult your
doctor before continuing to use your spa.

• The use of alcohol, drugs or medication before or during use of your CleverSpa® may lead
to unconsciousness with the possibility of drowning.

• People who have a history of heart disease, low or high blood pressure, circulatory system
problems or diabetes should consult a doctor before using CleverSpa®.

• People using medication should consult their doctor before using the CleverSpa®, as some
medications may cause drowsiness, whilst other medication may affect heart rate, blood
pressure and circulation during use.

• The water in a CleverSpa® should never exceed 42°C (107°F). Typical operating temperatures
are between 34-38OC (93-100°F), which are considered safe for a healthy adult. Lower water
temperatures are recommended for younger children, and when use exceeds 10 continuous minutes.
Since high water temperatures have the potential for causing foetal damage during the early months
of pregnancy, pregnant or possibly pregnant women, should limit the maximum CleverSpa® water
temperature to 38°C (100°F).

• The use of alcohol, drugs, or medication can greatly increase the risk of fatal hypothermia.
Hypothermia occurs when the internal temperature of the body reaches a level several degrees
above the normal body temperature of 37°C (98.6°F). The symptoms of hypothermia include an
increase in the internal temperature of the body, dizziness, lethargy, drowsiness and fainting. The
effects of hypothermia include failure to perceive heat, a failure to recognise the need to exit the
CleverSpa®, an unawareness of impending hazards, foetal damage in pregnant women, a physical
inability to exit the CleverSpa® and unconsciousness resulting in the danger of drowning.

• Immediately leave the CleverSpa® if you feel uncomfortable or sleepy.

• Do not turn the CleverSpa® on when it is empty as this could cause irreparable damage to the
pump system which would nullify any warranty period.

• The CleverSpa® should not be setup or left outside if it could be exposed to temperatures lower
than 4°C (39.2°F) as this could cause irreparable damage which could nullify any warranty period.

• Never add water to chemicals. Always add chemicals to water to avoid strong fumes or violent
reactions that may result in a hazardous chemical spray.

• In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must
not be supplied through an external switching device, such as a timer, or connected to a circuit
that is regularly switched on and off by the utility.

• WARNING: An adequate drainage system has to be provided to deal with overflow of water.

• IMPORTANT: Because of the combined weight of the CleverSpa®, water and users, it is extremely
important that the base where the CleverSpa® is installed is smooth, flat, level and capable of
uniformly supporting this weight for the entire time the CleverSpa® is installed (approximately
975kgs for a 6 Person Square CleverSpa® plus the combined weight of the occupants).

If the CleverSpa® is placed on a surface which does not meet these requirements, any damage

caused by improper support will void the warranty. It is the total responsibility of the CleverSpa®
owner to assure the integrity of the site at all times.

03

SS19 6 Person Square CleverSpa IM_AW.indd 3 30/10/2018 15:29

CLEVERSPA® PARTS CHECKLIST

Please check all parts are present in your box before first use.

To order new or missing parts please visit cleverspa.co.uk

FILTER CARTRIDGE (B)GROUNDSHEET (A)

FILTER PROTECTOR

COVER (C)

CLIP-ON TOP COVER (E)INFLATION HOSE (D) REPAIR PATCHES (F)

DRAINAGE PLUG (G)

SAFETY LOCKING

CLIP KEYS (H)

6 PERSON CLEVERSPA® PRODUCT SPECIFICATION

Capacity Up to 6 Adults

Water Capacity 950L (approx.)

Actual Water Flow 1,325L/H

Inflated Size 185cm x 185cm x 65cm

Product Weight 26Kgs (Approx)

Filled Weight 975kg (approx.)

No. of Bubble Jets 140

Rated Power Input for Heating 1800W

Rated Power Input for Bubbling 600W

Rated Current for Heating / Bubbling & Filtering 10.4A - For heating 7.8A / For bubbling 2.6A

Pump Voltage 220-240V–50Hz

Maximum Temperature 42oC (107oF)

Temperature Rise Approx. 1.5-2oC/hr

LIGHTING KIT (I)

(Where applicable)

Refer to pages 08 - 09

04

SS19 6 Person Square CleverSpa IM_AW.indd 4 30/10/2018 15:29

Indoors Installation

Be aware of special requirements if you install
your CleverSpa® indoors:

1. The floor must be able to withstand the
combined weight of the CleverSpa® and
occupants.

2. The floor should be a non-slip, level surface.

3. A suitable drainage solution is essential

when installing your CleverSpa® indoors.
Please carefully consider the placement of
your spa before installation.

PLEASE NOTE: Do not install the CleverSpa®
on carpet or other material that can be
damaged by water.

SS19 6 Person Square CleverSpa IM_AW.indd 5 30/10/2018 15:29

Outdoors Installation

1. No matter where you install your CleverSpa®,
it is important you have a solid support
foundation.

If you are installing the CleverSpa® outdoors,

ensure there are no sharp objects that could
damage it and that the location is level so the
CleverSpa® sits properly.

2. During filling, emptying or when in use, water
may spill out of your CleverSpa®. You should
install it near to a drainage point that is able
to accept the total volume of water.

3. Do not leave the CleverSpa’s surface exposed
to direct sunlight for long periods of time as
this may affect the strength of the welds.

05