Cleveland Motion Controls Clutch EMAG 9H User Manual
Specifications
Nominal torque 12 N.m ft.lbf 9
Minimal torque 0.14 N.m ft.lbf 0.1
Coil resistance - 20°C
Rated current DC A 0.55
Rotor inertia 0.25.10-3kg.m2lb.ft 25.8 10
Weight 4.6 kg lb 10.15
Heat dissipation
continuous sustained
depending on external
part rotation speed
* Heat dissipation is the mechanical power (P = cw) maximum allowable.
48
W * 130 550 900
(RPM) 0 1000 2000
W
23
Clutch
EMAG 9H
-3
61
3
7
891 Ø
30
46
55
+ 0,3
-0
Max. deepness 12
3,5
3
01 Ø
8h 55 Ø
5,
4
n
11 Ø
o °0
6
ta 5M sel
o
h 6
4 E9
31J 2,61
2 holes
Ø 4,1
+0,1
0
Ø 15 H7
92
Application Notes
• Mounting must be made without any stress.
Lubricated for life (other internal lubrication not allowed).
The shaft should be lubricated upon assembly, to prevent seizing.
• Low DC current power supply for coil.
• The standard device is designed for horizontal shaft orientation,
and a minimal speed of 60 RPM. Maximum speed is 2000 RPM
(without exceeding the max. heat dissipation capability).
• For Engineering application, please contact our technical support.
• In normal use, the outside temperature of the device can increase up to 100°C,
without damage.
14
12
10
mN euqroT
8
6
4
2
0
0 0,1 0,2 0,3 0,4 0,5 0,6 0,7 0,8
Current A
Safety
• If the device is to be used in dusty, humid or corrosive environment,
special protection needs to be considered.
Recommended mounting principles
In line mounting Parallel mounting
M
O
T
O
R
Rotating
shaft
EMAG 9H
M
O
T
O
R
Fixing flange
Flexible
coupling
Rotating shaft
Fixing flange
©Cleveland Motion Conrols, Inc.
7550 Hub Parkway • Cleveland, Ohio 44125
ph: 216.524.8800 or 800.321.8072 • fax: 216.642.2199
www.cmccontrols.com • email: literature@cmccontrols.com
Loading...