Cleveland SGM-30 Service Manual
Repair Manual
UNITED STATES
CANADA
Free Standing Gas
Skillets
Model SGM
Cleveland Range, Inc.
1333 East 179th St. Cleveland- Ohio 44110 Phone:
(216) 482 -4900 Telex 98-0546 FAX:(216) 481-3782
Garland Commercial Ranges ll77 Kamano
Road
Mississaugha Ontario Canada L4W1X4
Phone: (416) 624-0260 FAX- (416) 624-0623
Cleveland WARRANTY AND LIMITED EXTENDED
TOTAL DISSOLVED SOLIDS less than
60
parts per million
TOTAL ALKALINITY
less than
20
pans per million
SILICA
less than
13
parts per million
CHLORIDE
less than
30
parts per million
pH FACTOR
greater than
75
WARRANTY COVERAGE
LIMITED WARRANTY
Cleveland Range products are warranted to the original purchaser to be free from defects in material and workmanship
under normal use and service for the standard warranty period.
Cleveland Range agrees to repair or replace, at its option, f.o.b factory, any part which proves to be defective due to defects
in material or workmanship during the warranty period providing the equipment has been unaltered and has been PROPERLY
INSTALLED, MAINTAINED, AND OPERATED IN ACCORDANCE WITH THE CLEVELAND RANGE OWNER'S
MANUAL.
CLEVELAND RANGE agrees to pay any FACTORY AUTHORIZED EQUIPMENT SERVICE AGENCY (within the
continental United States, Hawaii, and Canada) for reasonable labor required to repair or replace, at our option, f.o.b. factory,
any part which proves to be defective due to defects in material or workmanship, during the labor warranty penod. This
warranty includes travel time not to exceed two hours and mileage not to exceed 50 miles (100 miles round-tnp), but does not
include post start-up, tightening loose fitting, minor adjustments, maintenance. cleaning or descaling.
The standard labor warranty allows factory payment of reasonable labor required to repair or replace such defective parts.
Cleveland Range will not reimburse the expense of labor required for the repair or replacement of parts after the standard
warranty penod, unless an Extended Labor Warranty Contract has been purchased to cover the equipment for the balance of
the warranty penod from the date of equipment installation, start-up, or demonstration.
PROPER INSTALLATION IS THE RESPONSIBILITY OF THE DEALER, THE OWNER-USER, OR INSTALLING
CONTRACTOR, AND IS NOT COVERED BY THIS WARRANTY. Many local codes exist and it is the responsibility of
the owner and installer to comply with these codes. Cleveland Range equipment is built to comply with applica ble standards
for manufacturers, including UL, A.G.A., NSF, ASME/Ntl Bd., CSA, CGA, ETL, and others.
BOILER (Steam Generator) MAINTENANCE IS THE RESPONSIBILITY OF THE OWNER-USER, AND IS NOT
COVERED BY THIS WARRANTY. The use of good quality feed water is the responsibility of the Owner-User (see Water
Quality Requirements below). THE USE OF POOR QUALITY FEED WATER WILL VOID EQUIPMENT WARRANTIES.
Boiler maintenance supplies, including boiler hand gaskets, are not warranted beyond the first 90 days after the date the
equipment is placed into service if no preventive maintenance records are available showing descaling every 90-120 days.
WATER QUALITY REQUIREMENTS
The foregoing shall constitute the sole and exclusive remedy of onginal purchaser and the full liability of Cleveland Range for any breach
of warranty. THE FOREGOING IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES WHETHER WRTTEN, ORAL OR
IMPLIED. INCLUDING ANY WARRANTY OF PERFORMANCE MERCHANTAB1LITY, OR FITNESS FOR PURPOSE. AND
SUPERSEDES AND EXCLUDES ANY ORAL WARRANTIES OR REPRESENTATIONS, OR WRIT TEN WARRANTIES OR
REPRESENTATIONS, NOT EXPRESSLY DESIGNATED IN WRITING AS A “WARRANTY" OR “GUARANTEE” OF CLEVELAND
RANGE MADE OR IMPLIED IN ANY MANUAL, LITERATURE, ADVERTISING BROCHURE OR OTHER MATERIALS.
Cleveland Range's liability on any claim of any kind including negligence, with respect to the goods or services covered hereunder, shall in
no case exceed the price of the goods or services, or part thereof which gives use to the claim, NO EVENT SHALL CLEVELAND RANGE
BE LIABLE FOR SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, OR ANY DAMAGES IN THE NATURE OF
PENALTIES.
LIMITED EXTENDED WARRANTY COVERAGE
The purchase of a Limited Extended Warranty Contract extends the standard warranty coverage to the purchased penod of
time (one to four years) from the date of installation start-up, or demonstration, whichever is sooner.
GAS SKILLET OPERATING CONTROLS AND
INDICATORS
For your better understanding and confidence, the following explanation of the control system used
on these skillets is offered.
Item No. Description Function
3 Gas Control Valve
(Skillet Bottom Dwg.)
Controls main gas supply to the skillet.
9 Micro (Cut-off) Switch
(Skillet Bottom Dwg.)
5 Thermostat Control Knob
(Control Panel Dwg.)
7 On/Off Toggle Switch
(Control Panel Dwg.)
11 Tilt Switch (Control Panel Dwg.) When activated, the skillet will tilt forward or back.
12 Operating Pilot Light (Orange)
(Control Panel Dwg.)
Protective switch to prevent burners from igniting while
skillet is in a tilted position.
This control knob allows the operator to select various heat
increments for operating the skillet.
Controls electric power to the skillet.
When illuminated, indicates that the burners are lit.
Use only replacement parts which are factory supplied as to preserve the certification of Underwriters Laboratories, American Gas
Associaton, Canadian Standards Association or Canadian Gas Association (as applicable). The use of other than factory supplied
replacement pans will void the warranty.
GAS SKILLET BOTTOM
Item No. Part No. Description Qty.
1 SK50337 Burner 3,4
2 SK50341 Orifice, Burner, Nat. Gas 3,4
(0-2000 ft. elev. #46 drill)
SK50343 Orifice, Burner, Nat. Gas 3,4
(2000-4000 ft- elev. #47 drill)
SK50344 Orifice, Burner, Nat. Gas 3,4
(4000-6000 ft. elev #48 drill)
SK50345 Orifice, Burner, Nat. Gas 3,4
(6000-8000 ft.elev #49 dnll)
SK50342 Orifice, Burner, LP. 3,4
(0-2000 ft. elev. #54 drill)
SK50346 Orifice, Burner, LP. 3,4
(2000.4000ft.elev #55 drill)
SK50347 Orifice, Burner, LP. 3,4
(4000-6000 ft. elev. #56 drill)
SK50348 Orifice, Burner, L-P. 3,4
(6000-8000 ft- elev #57 drill)
3 KE51155 Combination Gas Control Valve, 1
Nat. Gas, 24 VAC (Spark Ignition)
KE51163 Combination Gas Control Valve,
LP., 24 VAC (Spark Ignition)
KE5-1110 Combination Gas Control Valve, 1
Nat. Gas, 120 VAC (Manual Ignition)
KE51161 Combination Gas Control Valve, 1
LP-, 120 VAC (Manual Ignition)
4 KE51111 Pilot Flame Sensor 1
(Thermopile Type)
(Manual Ignition)
KE51159 Pilot Flame Sensor 1
(Mercury Vapor Type)
(Spark Ignition)
5 KE51114 Pilot Burner 1
6 KE01018 Ignition Electrode (Spark Ignition) 1
7 KE51116 Orifice, Pilot, Nat. Gas (.020") 1
KE51162 Orifice, Pilot, LP. (.0145') 1
8 SK50334 Zip Tube (SGM-30) 1
SK50335 Zip Tube (SGM-40) 1
9 SK50373 Micro (cut-off) Switch 1
10 SK50363 Orifice, Zip Tube, Nat. Gas. #61 drill 1
SK50364 Orifice. Zip Tube, LP., #72 drill 1
11 SK50252 Heat Spreader (R H. End Piece) 1
SK50249 Heat Spreader (L.h. End Piece) 1
SK50253 Heat Spreader (With Thermostat Cut-out) 1
SK50213 Heat Spreader (Plain) 3,5
12 SK50416 Washer, Spherical 28.36
13 FA21024 Nut, 5/16-18 28,36
3
Item No. Part No. Description Qty.
1 SK00028 Thermostat, Control / Safety 2
2 FA10140 Screw, Thermostat, 6-32 x 1 1/4" 2
3 SK00031 Bezel 1
4 FA10135 Screw, Bezel, 6-32 x 5/8'' 2
5 SK50059 Knob, Thermostat 1
6 SK50062 Rubber Boot 1
7 KE50504 Switch, Toggle, On/Off, SPST (115V Units) 1
SK50056 Switch, Toggle, On/Off, DPST 1
(208-240V Units)
8 SK50208 Circuit Breaker, 3 Amp 1
9 SK50370 Terminal Block, 2 Pole 1
10 KE51386 Capacitor, 27-32 MFD 1
11 SK50175 Switch, Rocker, Momentary 1
12 SK50315 Pilot Light 1
13 SK50371 Fuse Holder (manual ignition only) 1
14 KE51140 Fuse, 4/10 Amp (manual ignition only) 1
Use only replacement parts which are factory supplied as to preserve the cerfficabon of Underwriters Laboratories. American Gas
Association. Canadian Standards Association or Canadian Gas Association (as applicable). The use of other than factory supplied
replacement parts will void the warranty.
4
Loading...