Cleveland SGL-30-TRMPL User Manual

1333 East 179th St., Cleveland, Ohio, U.S.A. 44110 Ph: 1-216-481-4900 Fx: 1-216-481-3782 Web Site: www.clevelandrange.com
Cleveland Range, LLC
SINCE 1922
INNOVATIVE STEAM COOKING SOLUTIONS
SKILLETS
DuraPanSERIES
MODELS:
SGL-30-TRMPL SGM-30-TRMPLSGL-40-TRMPL SGM-40-TRMPL
ITEM NUMBER __________________________________________ JOB NAME / NUMBER __________________________________
Cleveland Standard Features
No Electrical Connection required
Leg or Modular Base
Hydraulic Hand Tilt with quick lowering feature
Stainless Steel Clad 5/8" Cooking Surface Guaranteed
against warping
Stainless Steel Coved Cornered Pans with both Gallon and Liter Markings
All Stainless Steel Construction for durability and easy cleaning
Adjustable Thermostat controls temperature from 100°F to 425°F
High Efficiency Heating System with even heat distribution
Fast Heat-Up and Recovery Time-Preheats in 11 minutes,
full capacity from cold to boiling in 60 minutes
Spring Assist Cover with Adjustable Vent and Full Width Handle
Thermostat Knob recessed to avoid breakage
Four Stainless Steel, Level adjustable feet, rear flanged
for bolting
All Controls are serviceable from the front of the unit
Splash Proof Controls
Thermopile Safety Device - if pilot goes out, gas supply is
shut off
High Limit Safety Device set at 475°F (246°C)
Anti-Splash Pouring Lip
Pilot Access Panel located at front of unit for easy access
Options & Accessories
Sliding Drain Drawer with Splash Screen (SLD) (for SGL
models only
Double or Single Pantry Faucet (SPS14, DPS14),
includes Faucet Mounting Bracket
Double or Single Pantry Skillet Filler with 60" hose (SKF-S or
DKF-S)
Hot & Cold Water Pre-Rinse Spray Head with Hose (PRS-S)Gas types other than naturalFood Strainers for pouring spout (FS)Vegetable Steamers (VS)
Shall be CLEVELAND, Tilting Skillet; Model SG
_____
-
_____
- TRMPL gas
(TYPE
_____
)- holding no less than _____ Gallons; complete with Thermostatic Safety and Gas Controls; Gallon Markings; Stainless Steel Clad 5/8" Cooking Surface; Hand Tilt; Spring Assist Cover with adjustable Vent. All Stainless Steel Construction.
Poaching Pans (PP)Wall Mounting (WMS)In-Wall Carrier (IWCS)Pan Carrier (PCS)2" Tangent Draw-Off V alve (TD2)
Short Form Specifications
SECT. XII PAGE 7B
1203
Open base model shown with optional Drain Drawer (SLD)
SECT. XII PAGE 8B
1203
Litho in U.S.A.
(NOT TO SCALE)
NOTES:
Cleveland Range reserves right of design improvement or modification, as warranted. Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes. Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are U.L., NSF, CGA, CSA, ETL and others.
32"
813mm
30"
762mm
SUGGESTED
FLOOR DRAIN GRATE
12"
305mm
23 1/2"
597mm
(PAN
SURFACE)
35"
889mm
40"
1016mm
37"
940mm
42"
1067mm
28"
711mm
26"
660mm
4 1/2"
114mm
33 1/2"
851mm
13"
330mm
26"
660mm
15 1/4"
387mm
3 1/2"
89mm
72"
1829mm (COVER
FULLY OPEN)
A B
(PAN SURFACE)
LIP (CENTERED ON SKILLET)
DRAIN PAN
TD 2
TD 2 & DRAIN PAN
DOUBLE PANTRY FAUCET
TD 2 OUTLET
PIPE DRAIN RECOMMENDED
MINIMUM VALVE SIZE PLUS 1" (26mm)
RECOMMENDED
FLOOR SLOPE
1" (26mm) IN
4' (1220mm)
PAN IN FULL
TILT POSITION
1 1/4 NPT (DRAIN PIPE)
DE
SUGGESTED
FLOOR DRAIN
GRATE FOR
TD 2
15"
381mm
28"
711mm
7/16"Ø, 3 HOLES ON 2 3/4" (70mm) B.C.D.
FLANGED FOOT DETAIL
(REAR LEGS ONLY)
120°120°
3 1/2" (89mm)
1" (26mm)
(MAXIMUM
ADJUSTMENT
2" (51mm)
4"
102mm
16 1/2"
419mm
6"
153mm
23"
584mm
PILOT ACCESS PANEL
6 1/4"
159mm
TYPE: NAT or LP WATER COLUMN: 4.5 (NAT), 10.5 (LP) BTU PER CU. FT.: 1000 (NAT), 2500 (LP) SUPPLY PRESSURE:
5" W.C. MIN (NAT), 11" W.C. MIN (LP)
BTU RATINGS:
SGL-30-TR:
91,000 per hour
SGL-40-TR:
130,000 per hour
MIN. TO COMBUSTABLE SURFACES:
SIDES: 0, REAR: 6" (153mm)
MIN. TO NON COMBUSTABLE SURFACES: SIDES & REAR: 0 NOTE: 4 1/2" (115mm) required on
right hand side for faucet
SGL-30-TR
440 LBS.
200 KG.
SGL-40-TR
520 LBS.
237 KG
APPROX. SHIPPING WEIGHTS
GAS SUPPLY (PIPING 3/4" NPT)
CLEARANCE
APPROVALS
AGA CGA NSF
SPECIFICATIONS
MODEL
SGL-30-TR
SGL-40-TR
A
36"
(915mm)
48"
(1220mm)
DIMENSIONS
B
32"
(812mm)
44"
(1118mm)
C
9"
(229mm)
12 1/8"
(308mm)
D
5"
(127mm)
8"
(203mm)
E
20"
(508mm)
22"
(559mm)
NOTE: NON STANDARD ITEMS ARE SHOWN IN GRAY
In 4 oz. servings. Other sizes may be calculated.
30 gallons / 115 Liters ............. 960
40 gallons / 150 Liters ............1280
CAPACITIES
Loading...