Cleveland Enodis IWC-PDW Specifications

Cleveland

™

P

roject ________________________________

I

tem __________________________________

Quantity _______________________________

FCSI Section ____________________________

A

pproval _______________________________

D

ate __________________________________

1333 East 179 St.,

Cleveland, Ohio, U.S.A. 44110

Tel: [phone]

Fax: [phone]

Web Site: www.ClevelandRange.com

Email: [e-mail]

OPTIONS & ACCESSORIES

IN-WALL CARRIER

FOR USE WITH WALL MOUNTED,
DIRECT STEAM, PRESSURE STEAMERS

Cleveland Standard Features

n Welded Steel Construction

n Furnished with 8 each 5/8"-11 NC studs for supporting

steamer Carrier Channels. Does not include necessary
Double Hex Nuts (16 each 5/8"-11 NC)

n Provided with eight, floor studs holes (11/16" Diameter)

to receive pre-set floor studs (5/8" diameter)

n To be imbedded in floor and wall and covered with

appropriate surfaces

n In-Wall Carrier is required for Wall-Mounted Units and

should be included in specification for Steamer

n Completed installation provides unobstructed floor area

for cleaning

Options & Accessories

p Mounting Studs, in lengths other than standard

MODEL: c IWC-PDW

Shall be CLEVELAND, Model IWC-PDW, In-Wall Carrier, Steel, for installing
Cleveland Pressure Steamers. Includes (8) Supporting Studs 5/8" - 11 x
2 1 /2" long .

Short Form Specifications

SECT. XIII PAGE 5

0707

TES

NO

:

Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are U.L., NSF, CGA, CSA, ETL and others.

(NOT

SECT

O SCALE)

T

.

AGE

XIII P

Litho in U.S.A.

6

0707