Cleveland CST-620 User Manual

Cleveland

™

P

roject ________________________________

I

tem __________________________________

Quantity _______________________________

FCSI Section ____________________________

A

pproval _______________________________

D

ate __________________________________

1333 East 179 St.,

Cleveland, Ohio, U.S.A. 44110

Tel: [phone]

Fax: [phone]

Web Site: www.ClevelandRange.com

Email: [e-mail]

by

Cleveland

COMBI OVEN-STEAMER
Options & Accessories

Stacking Stand for one Cleveland 6.20 Combi
and one Convection Oven

Cleveland Standard Features:

n Stand frame constructed of 1 1/2" thick wall, square tubing
n Solid top for directing heat away from Combi
n Crossbar supported on three sides
n Corner gussets for additional rigidity
n 16 gauge stainless steel table top
n Four, one (1) inch high locator pins for mounting 6.20 combi on

stand

n Stand restraining device (for CST-620CA only)
n Four level adjustable flanged feet (CST-620)
n Four heavy duty 3" diameter swivel casters,

two with brakes (CST-620CA)

n Service friendly and easy to clean
n UL Sanitation approved, according to NSF2 standards

MODEL: c CST-620 (with feet)

c CST-620CA (with casters)

IT EM NU M B E R __________________________________________

JOB NA ME / NUMB ER __________________________________

Notes:

p The stands are designed to accommodate full or half size gas or

electric Convection Ovens

p The stands are built to support all Cleveland 6.20 Combi models

p The Convection Oven must always be installed on the bottom

m Specifications

t For

Shor

Shall be Cleveland Model: CST-620___ Stacking Stand for one Cleveland

6.20 Combi and one full or half size Convection Oven. Stand frame
constructed of 1 1/2" thick wall, square tubing. Crossbar supported on three
sides. 16 gauge stainless steel table top. Four, one (1) inch high locator pins
for mounting 6.20 combi on stand. Stand restraining device (for CST-620CA
only). Four level adjustable flanged feet (CST-620) or four heavy duty 3"
diameter swivel casters, two with brakes (CST-620CA).

SECT. IIB PAGE 18

0707

45.00”

43.00”

6.50”

43.00”

6.50”

47.92” 40.44”

3.18”

38.26”

43.00”

78.50”

50.00”

45.00”

50.00”

CST-620 (with feet) CST-620 (with casters)

The Convection Oven manufacturer and installers are responsible

for proper venting and if needed installing a flue diverter for the

Convection Oven (not supplied by Cleveland Range).

NOTES:

Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Cleveland Range equipment is built to comply with applicable standards for manufacturers.

SECT

.

IIB P

AGE

19

0707