Cleveland CST2610MOB User Manual
Cleveland
™
P
roject ________________________________
Item __________________________________
Quantity _______________________________
F
CSI Section ____________________________
A
pproval _______________________________
D
ate __________________________________
1333 East 179 St.,
Cleveland, Ohio, U.S.A. 44110
Tel: 1-216-481-4900
Fax: 1-216-481-3782
Web Site: www.ClevelandRange.com
Email: Steam@ClevelandRange.com
71.73”
45.50”
69.98”
40.23
15.75”
30.88”
23.50”
20.28”
6.19”
36.33”
3
4.71”
3
0.56”
22.13”
THE "mini" COMBI OVEN-STEAMER
Stacking Kit for Electric Table Type Models
(OES 6.10 mini on OES 6.10 mini)
Model # Description
CST2610MOB for mounting two OES 6.10 mini models
CST2610MOBCA for mounting two OES 6.10 mini models with casters
UTILITIES (Utility connection shown below are listed per unit)
ELECTRICAL CONNECTIONS
The 3 phase 208-240 volt units will be supplied with a 10 AWG,SOOW, 4
conductor 6 foot long cord. The customer will have to provide the NEMA plug
(NEMA # 15-30P or L15-30P). Unit current rating 17.9 amps.
The 1 phase 208-220 volt units will be supplied with a 10 AWG, SOOW, 3
conductor 6 foot long cord. The customer will have to provide the NEMA plug
(NEMA # 6-30P or L6-30P). Unit current rating 22.7 amps.
The 1 phase 240 volt units will be supplied with a 10 AWG, SOOW, 3
conductor 6 foot long cord. The customer will have to provide the NEMA plug
(NEMA # 6-50P or L6-50P). Unit current rating 24.5 amps.
These units cannot be hard wired to the circuit box. They must have a NEMA
plug to be connected to a mating NEMA receptacle (customer supplied) to
comply with the U.L. and NEC electrical standards.
OPTIONS & ACCESSORIES
CSH2610 Smooth action spray hose for stacked units
COLD WATER CONNECTION
One 3/4" GHT (Garden Thread Hose) connection. Use NSF approved hose.
35 PSI minimum, 60 PSI maximum.
NOTE: The owner / operator / purchaser must ensure that the Water Quality Requirements are met.
Not meeting the water quality requirements will void the original equipment warranty.
Water Quality Requirements:
TDS . . . . . . . . . . . . < 60 ppm pH Factor . . . . . 7.0 – 8.5
Total Alkalinity . . . . < 20 ppm Free Chlorine. . . < 0.1 ppm
Silica . . . . . . . . . . . < 13 ppm Conductivity . . . min. 20 µS/cm (50 kOhms)
Chloride . . . . . . . . < 25 ppm
DRAIN CONNECTION
1 1/2" tube.
Do not connect other units to this drain.
Drain line must be vented.
SERVICE CLEARANCES
3" left, 3" right, 3" rear, allow 20" on top for service.
SECT. IIB PAGE 5N
0911
Loading...